Dimension Guide
Built-in ovens / underbench
Models:
- EVEP614SD
- EVEP614DSD
- EVEP616DSD
- EVEP618DSD
Pyrolytic cut-out dimensions
| Type of fit | A (width) | B (height) | C (depth) | D* |
|---|---|---|---|---|
| Flush fit (mm) | 600 | 600 | 581 min. | 20 |
Installation Diagram Description
The diagram illustrates the installation of a built-in oven into a cabinet, detailing the necessary cut-out dimensions for pyrolytic models.
Key dimensions shown are:
- Cabinet width: 561 mm
- Oven width: 596 mm
- Mounting holes: 582 mm
- Ventilation gap (D): 20 mm
The table provides specific measurements for a 'Flush fit':
- Width (A): 600 mm
- Height (B): 600 mm
- Depth (C): 581 mm minimum
Please note: Dimensions provided are for guidance only. Customers must refer to the user manual supplied with the product for detailed installation instructions.
* D - Dimension: For proper ventilation, a gap is required at the bottom rear of the cabinet. This can be a 20mm deep slot or an equivalent full-width opening (e.g., a series of holes) with a minimum area of 120cm². This opening must remain clear of the product when fully installed. This requirement applies to any EVEPxxxxx model. The power point connection for the EVEP618 must be accessible with the appliance fully installed. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.
