Instruction Manual for THE GREAT OUTDOORS models including: 71260-1-66 Black Outdoor Wall Light, 71260-1-66, Black Outdoor Wall Light, Outdoor Wall Light, Wall Light, Light
Harbor View 1-Light 12.125-in Black Outdoor Wall Light 747396114392
Minka-Lavery 71260-66-C Great Outdoors Harbor View 1 Light 12.13 inch Sand Coal Outdoor Wall Mount in Clear Glass
INSTALLATION INSTRUCTIONS Model# 71260/1-66 READ AND SAVE THESE INSTRUCTIONS W ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. PREPARING FOR INSTALLATION (Fig. 1) 1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts in a clear Fig. 1 Mounting plate (1) (Part#A-020) Ground screw (1) Mounting screws (2) area. Take care not to misplace any small parts necessary for installation. 3. Screw the mounting screws (C) into mounting plate (B) ensuring they are spaced the same distance apart as the holes in the back plate (G). B 4. Attach mounting plate (B) using outlet box screws (F) to the outlet box (A) (not supplied). The side of mounting plate marked "GND" must face out. (Fig 1) CONNECTING THE WIRES (Fig. 2) G HQ D C E 5. Connect the electrical wires as shown in Fig 2. with connectors (E), making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture's ground wire to it. Otherwise, connect the fixture's ground wire directly to the mounting plate (B) using the green screw (D) provided. After the wires are connected, carefully tuck them inside the outlet box. F FINISHING THE INSTALLATION (Fig. 1) 6. Place the back plate (G) over mounting screws (C), follow by rubber gasket (Q), then secure to wall using cap nuts (H). (Fig 1) 7. To prevent moisture from entering the outlet box (A) and causing a I short, use clear silicone sealant to outline the outside of fixture back plate (G) where it meets the wall leaving a space at bottom to allow moisture a means to escape. (Fig.3) 8. To replace the glass, remove gaskets (M,8pcs) and loosening the screws (L,8pcs) to remove cover (K). Insert the new glass (J) into the J fixture frame from the bottom. Secure the lower cover (K) by screwing screws (L,8pcs) until tight and reinstalling gaskets (M,8pcs) on the lower cover (K). K 9. Install (1) one medium base bulb (I) up to 60 Watts, or CFL or LED L equivalent (not included), in accordance with the fixture specification. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING) (NE PAS M DEPASSER LA PUISSANCE NOMINALE MAXIMALE!) 10. This fixture is ETL listed for wet location applications. Your installation is now complete. Return power to the outlet box and test the fixture. F ig.2 FIXTURE WIRES BLACK FIXTURE WIRES WHITE FIXTURE WIRES GREEN OR BARE COPPER (GROUND) HOUSE WIRES BLACK (HOT) HOUSE WIRES WHITE (NEUTRAL) HOUSE WIRES GREEN OR BARE COPPER(GROUND) Fig 3 "CAUTION-RISK OF FIRE CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR" ATTENTION RISQUE D'INCENDIE, CONSULTER UN ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS. Backplate CaulkingMicrosoft: Print To PDF