Parallax Forums
Parallax Inc | Equip Your Genius®
Instruction Manual for PARALLAX INC models including: 40012, Ag9050, Power over Ethernet Module, Ag9050 Power over Ethernet Module, 40012 Ag9050 Power over Ethernet Module
[no anchor text]
File Info : application/pdf, 3 Pages, 212.19KB
DocumentDocumentWeb Site: www.parallax.com Forums: forums.parallax.com Sales: sales@parallax.com Technical: support@parallax.com Office: (916) 624-8333 Fax: (916) 624-8003 Sales: (888) 512-1024 Tech Support: (888) 997-8267 Ag9050 Power over Ethernet Module (#40012) The Ag9050 Power over Ethernet Module is designed to be a drop-in Power over Ethernet (PoE) solution for the WI Znet W5200 Ethernet Board. As long as your network supports power over Ethernet the W5200 + QuickStart board can both be powered and communicate. Features Power over Ethernet for your WI Znet W5200 Board and P8X32A Propeller QuickStart Board Regulated 5 V output powers your QuickStart Board and other peripherals Overload and short-circuit protection I ndustrial operating temperature range Key Specifications Power Requirements: Power Sourcing Equipment (PSE) or Midspan Equipment Power Output: 9 watt max power output (5 V @ 1.8 A) Communication I nterface: Complies with I EEE 802.3af Operating temperature: -40 to + 185 °F (-40 to + 85 °C) Dimensions: 3.0 x 2.0 in (7.62 x 5.08 cm) Application Ideas Remote I P based security system I P based home automation Long distance tethered robotics Additional Items Required Power Sourcing Equipment (PSE) or Midspan Equipment WI Znet W5200 Board (# 40002) P8X32A Propeller QuickStart (# 40000) Soldering iron Solder Safety glasses Copyright © Parallax Inc. Downloaded from Arrow.com. Ag9050 Power over Ethernet Module (#40012) v1.0 8/6/2013 Page 1 of 3 Assembly Instructions 1. Make sure your QuickStart + W5200 boards have been safely powered down and carefully separated. Set the QuickStart board aside. 2. Carefully insert the Ag9050 Power over Ethernet module from the top down so that the module's large transformer is facing outward. The module is pin-keyed, so you cannot insert the module backw ar ds. 3. Use your soldering iron to solder the Ag9050 module into place from the underside of the W5200 module. Apply solder to all of the module's pins. Make sure there are no accidental solder bridges. 4. Check that your board setup looks like this when you're done soldering. Ag9050 PoE Module installed into the W5200's PoE header. Copyright © Parallax Inc. Downloaded from Arrow.com. Ag9050 Power over Ethernet Module (#40012) v1.0 8/6/2013 Page 2 of 3 5. Reattach your QuickStart Board and any other peripherals you may have added. 6. Connect an Ethernet cable to the W5200. The Ag9050 PoE module should automatically negotiate with Power Sourcing Equipment and begin supplying power to the QuickStart board. Resources and Downloads Check for the latest version of this document and datasheets from the Ag9050 Power over Ethernet Module product page. Go to www.parallax.com and search 40012. Revision History Version 1.0 Original Document Copyright © Parallax Inc. Downloaded from Arrow.com. Ag9050 Power over Ethernet Module (#40012) v1.0 8/6/2013 Page 3 of 3