Installation Guide for ULINE models including: H-4078, Plastic Rack Protector
de que la lengüeta sujete la pata del rack. Estire el protector alrededor de la pata del rack. (Vea Diagrama 1). 2. Presione hacia abajo el centro del ...
File Info : application/pdf, 3 Pages, 727.86KB
DocumentDocumentH-4078 PLASTIC RACK PROTECTOR 1-800-295-5510 uline.com Para Español, vea página 2. Pour le français, consulter la page 3. INSTALLATION INSTALLING PLASTIC RACK PROTECTOR 1. Position plastic rack protector behind the back corner of the rack leg so the tab latches onto the rack leg. Stretch rack protector around rack leg. (See Figure 1) Figure 1 3. Rotate rack protector around rack leg. Snap tab securely over back corner and secure with bolt and wing nut. (See Figure 3) Figure 3 RACK LEG Tab 2. Press center of rack protector down, pushing tab over opposite corner of rack leg. (See Figure 2) Figure 2 RACK 4. Stack to desired height. (See Figure 4) Figure 4 9" 18" PAGE 1 OF 3 RACK LEG Tab 0621 IH-4078 H-4078 PROTECTOR DE PLÁSTICO PARA RACK 800-295-5510 uline.mx INSTALACIÓN INSTALAR EL PROTECTOR DE PLÁSTICO PARA RACK 1. Coloque el protector de plástico detrás de la esquina posterior de la pata del rack de manera de que la lengüeta sujete la pata del rack. Estire el protector alrededor de la pata del rack. (Vea Diagrama 1) Diagrama 1 3. Gire el protector alrededor de la pata del rack. Cierre la lengüeta de forma segura sobre la esquina posterior y sujétela con un perno y una tuerca de mariposa. (Vea Diagrama 3) Diagrama 3 PATA DEL RACK Lengüeta 2. Presione hacia abajo el centro del protector del rack, empujando la lengüeta por arriba hacia la esquina opuesta de la pata del rack. (Vea Diagrama 2) Diagrama 2 RACK 4. Estibe a la altura deseada. (Vea Diagrama 4) Diagrama 4 22.9 cm (9") 45.7 cm (18") PAGE 2 OF 3 PATA DEL RACK Lengüeta 0621 IH-4078 H-4078 PROTÈGE-SUPPORT EN PLASTIQUE 1-800-295-5510 uline.ca INSTALLATION INSTALLATION D'UN PROTÈGE-SUPPORT EN PLASTIQUE 1. Placer le protège-support en plastique derrière le coin arrière du pied du support de sorte que la languette s'enclenche sur le pied du support. Étirer le protège-support autour du pied du support. (Voir Figure 1) Figure 1 3. Tourner le protège-support autour du pied du support. Enclencher la languette par-dessus le coin arrière, sécuriser avec un boulon et un écrou à oreilles. (Voir Figure 3) Figure 3 SUPPORT PATTE DE SUPPORT Languette 2. Enfoncer le centre du protège-support, en poussant la languette par-dessus le coin opposé du pied du support. (Voir Figure 2) Figure 2 4. Empiler jusqu'à la hauteur voulue. (Voir Figure 4) Figure 4 22,9 cm (9 po) 45,7 cm (18 po) PAGE 3 OF 3 PATTE DE SUPPORT Languette 0621 IH-4078Adobe InDesign 14.0 (Macintosh) Adobe PDF Library 15.0