Grandstream HT802 V2: Quick Installation Guide

Introduction

This guide provides essential information for the quick setup and installation of the Grandstream HT802 V2, an Analog Telephone Adapter (ATA). This device enables users to create high-quality IP telephony solutions for both residential and office environments, supporting analog phones and fax machines over an IP network.

Key Features

• 2 FXS ports for analog phone/fax connection
• 1 Ethernet port for network connectivity
• Micro-USB power input
• Web GUI and IVR for configuration
• Support for high-quality voice and advanced VoIP functionality

Getting Started

To connect your HT802 V2, follow these steps:

1. Connect an analog phone or fax machine to one of the FXS ports using an RJ11 cable.
2. Connect the Ethernet port to your router or gateway using an Ethernet cable.
3. Connect the power adapter to the HT802 V2 and plug it into a wall outlet.
4. The device is ready for configuration once the Power, Ethernet, and Phone LEDs are lit.

For detailed configuration instructions and troubleshooting, please refer to the official Grandstream website:

Important Precautions

• Do not attempt to open, disassemble, or modify the device.
• Use only the provided 5V power adapter.
• Avoid exposing the device to extreme temperatures or humidity outside the specified ranges.
• Do not power cycle the device during system boot-up or firmware upgrades.

Regulatory Information

The HT802 V2 complies with FCC Part 15 regulations and relevant EU directives. For full details on compliance and specifications, please visit the Grandstream website.