NICOR Lighting
Instruction Manual for NICOR models including: T4A LED Troffer, T4A, LED Troffer, Troffer
T4A Series 2x4 Ft. Parabolic LED Troffer in 5000K – BulbAmerica
File Info : application/pdf, 2 Pages, 324.39KB
DocumentDocumentT4A LED TROFFER INSTALLATION INSTRUCTIONS The installation must only be performed by a licensed electrician. To prevent death, injury or damage to property, this product must be installed in accordance to National Electrical Code (NFPA70) in the US or Canadian Electrical Code (CSA 22.1) in Canada. Disconnect power before installing the product or servicing it. Wait until fixture has cooled down before installing or servicing the fixture. MIN. 90°C SUPPLY CONDUCTORS What's In The Box Tools Needed This LED Troffer requires very few tools for installation. A drill or a screwdriver and a pair of wirecutter. One (1) T4A LED Troffer Wire Nuts 1 Carefully unpack the fixture from its packaging. Inspect product for defects due to shipping. 2 Locate desired positioning for fixture in ceiling grid. Remove ceiling tiles if necessary. 3 Turn off power to appropriate circuit at the breaker panel. 4 Place fixture into the T-grid ceiling panel. Secure to structure and/or grid per state and local codes. NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 7, 2017 3:36 PM rev 1.0 5 Remove cover from power supply juntion box by removing (2) two screws (do not discard). 7 Reattach cover of junction box and secure with (2) two screws. 6 Connect wiring as shown. Grey and purple wiring are for 0-10V dimming systems. Cap off if not used. Com Line GND White Black Junction Box Black Red Grey Purple Luminaire 1-10V (-) 1-10V (+) LED Driver Black Red * * *Cap off if not used 8 Turn power on and verify that the panel is lit. NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com July 7, 2017 3:36 PM rev 1.0