BASELAYR DARKROOM EQUIPMENT

TIMER OPERATION

Set the desired time in minutes and seconds using the up and down arrow inputs:

• 1: Seconds (0-9)
• 2: Tens of seconds (10, 20, 30, etc.)
• 3: Minutes (0-9)
• 4: Tens of minutes (10, 20, 30, etc.)

The timer display features two time readouts. The primary display shows the set time or current time, and a secondary display shows the countdown. The timer has four input sections, labeled 1 through 4, corresponding to the units of time: seconds, tens of seconds, minutes, and tens of minutes. Each section has associated up and down arrow buttons for adjustment.

Note: Logos, graphic elements, and/or photo images contained in this document may not be reproduced without the written consent of Ryonet.

SCREEN EXPOSURE

Once your screen has been coated with emulsion and the direct imaging has been placed, insert the frame into the unit with the mesh side out as shown. Set the digital timer as previously explained in the timer overview. Close the door. Once the door is closed, press the start button to begin the exposure process.

Maximum frame size: 25" x 36".

The unit features a digital timer display (labeled 2) on its front panel. The process involves inserting the screen (indicated by 1, the door) into the main body of the unit (indicated by 3). The top of the unit is indicated by 4. A note specifies to orient the screen with the "Mesh this side" facing inwards.

3-YEAR ELECTRICAL LIMITED WARRANTY

WHAT IS COVERED?

BASELAYR warrants any BASELAYR-branded electronic equipment to be free from defects in materials and workmanship for a period of 3 years from the original date of purchase. This warranty covers all BASELAYR branded manufactured electrical equipment, excluding standard consumables, to be protected against defects, damages, or malfunctions under normal use during the warranty period. If a defect is discovered in a product covered by this warranty, BASELAYR will replace the part to repair the product, using new or refurbished components, or if repair is not possible, replace the item, free of charge.

WHAT DOES THIS WARRANTY NOT COVER?

Shipping or travel associated with a replacement or repair is not covered. Any problem caused by abuse, misuse, or any "Act of God" circumstance (such as a flood) is not covered. Also, the replacement of any standard consumables that have a natural wear and tear rate that will eventually result in that item needing to be replaced is not covered.

This warranty is non-transferable and can only be used by the original purchaser.

If standard consumables are faulty or damaged upon receipt, BASELAYR will need to be notified within the first 48 hours.

Note: Logos, graphic elements, and/or photo images contained in this document may not be reproduced without the written consent of Ryonet.