Factory Direct LED Recessed Lighting, Outdoor Wall Lights, Ceiling Fixtures and Electrical Products
Installation Guide for Maxxima models including: MRL-S41523S 4 Square Anti Glare LED Downlight, MRL-S41523S, 4 Square Anti Glare LED Downlight, Anti Glare LED Downlight, LED Downlight, Downlight
Maxxima 4 in. Low Kelvin Ultra-Thin Square Recessed Anti-Glare LED Downlight, Canless IC Rated, 1200 Lumens, 3 Color Temperature Selectable 2200K/2400K/2700K 3 CCT, Dimmable, Junction Box Included
4 in. Low Kelvin Square Canless Recessed LED Downlight 3 CCT
File Info : application/pdf, 1 Pages, 1.19MB
DocumentDocument4" Square Anti-Glare Installation Guide MRL-S41523S www.maxximastyle.com WARNINGS · Risk of electric shock - Disconnect power at the source before installation. · If you are unsure about the installation or the maintenance of the fixture, please consult an electrician. · Do not make or alter any holes in the wiring enclosure or modify any electrical componentry. CAUTIONS · The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances. · Supply conductors must at least be rated for 90°C/194°F. · This fixture is designed for use with 120Vac, 50/60Hz only. INSTALLATION INSTRUCTIONS 1. Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel. 2. After marking the center point of where the fixture will be located, using the provided template cut the required hole shown in figure 1 which has a diameter of 4inches or 108mm. 3. Open the junction box, remove the desired knockout and attach a twin screw clamp connector (or similar) (not provided or necessary). 4. Insert the supply wire through the twin screw clamp connector (or similar) (not provided) shown in figure 2a. 5. Connect the hot (black) wire to the black wire, the neutral (white) wire to the white wire and the ground (green/bare copper) wire to the green wire using the provided wire nuts shown in figure 2. 5a. Optional - Using the selector switch inside the metal junction box the CCT can be changed to any of the three settings (CCT settings are 2200K/2400K/2700K). 6. Put all of the wires into the metal junction box and close the junction box. 6a. Optional - using a screw (not provided), the junction box can be mounted using the holes in the back of the junction box. 7. Connect the male output connector from the junction box with the female connector from the fixture and tighten the locking nut. 8. To insert the fixture into the hole, hold the two spring clips in the vertical postion until the springs are past the top of the ceiling material shown in figure 4. 9. Push the fixture up until flush with the ceiling shown in figure 5. 10. Installation is now complete, restore power and the fixture is now operational. Supply Ground Wire Supply White Wire Fixture Ground Wire Fixture White Wire Supply Black Wire Figure 1 Fixture Black Wire Figure 2 Figure 4 Figure 5 Figure 2a Figure 6 3 YEAR WARRANTY Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product. info@maxximastyle.com 866-MAXXIMA (629-9462) www.maxximastyle.com 125 Cabot Court Hauppauge, NY 11788