Icom AH-7000 Super Wideband Omnidirectional Antenna
Instructions
Product Overview
The Icom AH-7000 is a super wideband omnidirectional antenna designed for versatile communication applications.
Specifications
- Frequency coverage: Receive: 25 to 1300MHz, Transmit: 50, 144, 430MHz
- Input power rating: 200 watts
- Input impedance: 50 ohms
- Supplied connectors: Type N (Female)
- Type of antenna: Discone
- Length: 1.7 meters
- Weight: 1kg
Assembly Instructions
Follow these steps for the installation of the AH-7000 antenna. Numbers in circles indicate the order of installation.
-
Remove the three screws from the mounting pipe, and separate the cone elements from the antenna base. Pass the coaxial cable through the mounting pipe as shown.
Components:
- Plastic Cap (Small)
- Top Element
- Set Screw
- Loading Coil
- Disk Element (280mm) - Install the disk elements after installing the cone elements.
- Nut (M4)
- Antenna Base
- Spring Washer
- Hex Wrench
-
To prevent the cone elements from falling, set the set screws about 1-1/2 turns beyond the first point of contact with the elements.
Install the ends of the cone elements containing the spring washers into the antenna base.
- Cone Elements (820mm)
-
Plastic Cap (Large)
-
Mounting Brackets
U-CLAMP mounting hardware for tubing with a diameter of 25 to 60mm (1 to 2-1/3 inch).
- U-Clamps
- Nut (M5)
- Nut (M5)
- Spring Washer
- Screw
- Star Washer
- Screw (M3)
- Mounting Pipe
- Coaxial Cable
- Type N Connector
Diagram Description: The diagram illustrates the assembly of the Icom AH-7000 antenna. It shows the various components including the top element, loading coil, disk elements, cone elements, antenna base, mounting pipe, and U-clamp hardware. Dimensions are provided, indicating the length of the disk elements (280mm), cone elements (820mm), and the overall height and width of the antenna structure. The diagram also shows the connection of the coaxial cable via a Type N connector.
Dimensions
The antenna has a total height of approximately 920mm. The base structure has a width of approximately 800mm, with elements extending out to 820mm. The central mounting pipe section is approximately 280mm.
