OMNIKEY Smart Card Readers Installation Guide
PLT-02395, Rev A.3
eBase Models
1021, 3021, 3121, 5021, 5022, 5023, 5025, 5027, 5127, 5421, 5422, 5427, 6121
Drivers and Manuals available at: www.hidglobal.com/omnikev
Contact Information
Americas and Corporate: 611 Center Ridge Drive, Austin, TX 78753, USA
Asia Pacific: 19/F 625 King's Road, North Point, Island East, Hong Kong
Europe, Middle East and Africa: Phoenix Road, Haverhill, Suffolk CB9 7AE, England
For support, visit: www.hidglobal.com/support
Introduction
This guide describes the physical behavior and conformities of OMNIKEY Smart Card Readers.
- 1021 USB: Desktop smart card reader in a small form factor for desktop and mobile usage.
- 3021 USB: High-performance smart card reader with a USB interface and small form factor for desktop and mobile usage.
- 3121 USB: High-performance smart card reader for desktop use with multiple standing base options in a robust housing.
- 5021 USB: Contactless Reader with USB interface for desktop use that reads/writes to 13.56 MHz smart cards.
- 5022 USB: Contactless Reader with USB CCID-compliant interface for desktop use that reads/writes to 13.56 MHz smart cards.
- 5023 USB: A 5022 Reader with iCLASS and Seos support.
- 5027 USB: A 5023 Reader with Keyboard wedge.
- 5025 CL USB: Contactless Reader with USB CCID-compliant interface for desktop use that reads contactless (125 kHz) Prox cards.
- 5127 / 5427 CK / 5427 UE USB: Contactless 13.56MHz/125kHz reader with CCID/Keyboard wedge interface.
- 5427 G2: Contactless 13.56MHz/125kHz reader with CCID/Keyboard wedge interface and BLE.
- 5421 / 5422 USB: Dual interface PC-linked reader that reads/writes to 13.56 MHz contactless cards and virtually any contact smart card. 5422 includes CCID.
- 6121 Mobile USB: Dongle-sized smart card reader for SIM-sized smart cards, especially well suited for use with mobile devices.
Specifications and Installation
For further information, contact HID support: www.hidglobal.com/support
For driver setup, consult the OMNIKEY Smart Card User Guide.
CAUTION: Install the drivers prior to attaching the OMNIKEY reader with the computer.
ATTENTION: Vous devez installer le driver avant de connecter le lecteur OMNIKEY à l'ordinateur.
USB Connected Reader Specifications
| Operating Temperature | 32°F to 131°F (0°C to 55°C) |
| PC Connector Cable | 59.1 in (150 cm) for models 1021, 3021, 3121, 5021, 5022, 5023, 5025 CL, 5027, 5422, 5427 G2 |
| 78.7 in (200 cm) for models 5421, 5427 CK | |
| Mean Time Between Failures (MTBF) | 500,000 Hours |
| Host Interface | USB 2.0 CCID (USB 1.1 Compatible) |
| Host Data Transmission Speed | 12 Mbps (USB 2.0 Full Speed) |
| Power Supply | Bus Powered |
USB Connected Reader Installation
- Connect the reader with the computer; plug the USB connector into your computer's USB port.
- When the reader is operational, the LED illuminates.
- For contactless operation, hold the card next to the reader logo. For contact smart cards, insert the card into the reader with contacts facing up.
- The LED blinks when the reader is exchanging data with a card (reading/writing).
Regulatory Information
CAUTION: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
ATTENTION: Tout changement ou modification de cet appareil sans approbation explicite du manufacturer vous enlève les droits d'usage de cet équipement.
FCC (All Readers)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC (Readers 1021, 3021, 3121, 6121)
Tested to comply with FCC standards FOR HOME AND OFFICE USE.
Product Radio Certifications
The OMNIKEY 5022 CL and 5127CK MINI Module were tested under the FCC rules and Industry Canada rules for a Modular Approval. The end integrator may use the FCC/IC IDs provided that the Antenna and tuning network have not been changed and the original HID Global Label is visible.
- FCC ID: JQ6-OK5022CL or IC ID: 2236B-OK5022CL
- FCC ID: JQ6-OK5127CKMINI or IC ID: 2236B-OK5127CKMINI
The end user/manufacturer will not need to repeat intentional emissions testing, but unintentional emissions testing must meet FCC and IC requirements with the module installed. This also applies to CE Marking as defined by the R&TTE Directive.
If the HID OEM modules Kit is modified in any way, or if other radios exist in the final product, Radio Certification is required for the final product.
FCC Certification can be obtained by submitting the final product to a Telecommunications Certified Body (TCB) laboratory. Standards include Part 15, Subpart C for FCC, RSS-210, RSS-GEN, and RSS-310 for Canada, and R&TTE Directive requirements (EN 300 330, EN 301 489-3, EN 50130-4, IEC60950) for CE Marking. Australia and New Zealand requirements (AS/NZS 4268) may also be tested by the same laboratory.
Asian country certifications are obtained on an individual country basis.
US Dept. of Commerce Bureau of Industry and Security (BIS) approval is required for USA based companies who export and re-export products using encryption.
Regulatory Compliance Assistance: HID Global provides technical assistance and laboratory recommendations.
CAUTION: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
Canada Radio Certification (All Readers)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
CE Marking (All Readers)
HID Global hereby declares that these proximity readers are in compliance with the essential requirements and other relevant provisions of Directive 2006/95/EC.
(Declarations in Spanish, French, Portuguese, German, and Italian are also provided in the original document.)
Download the R&TTE Declaration of Conformity (DoC) at: http://www.hidglobal.com/certifications
Brazil (Readers 5022, 5023, 5422 and 5427 G2)
"Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário"
Chile (Readers 5022, 5422 and 5427 G2)
(No specific text provided for Chile in the excerpt)
China (Readers 1021, 5022, 5422, 5427 and 5427 G2)
(No specific text provided for China in the excerpt)
Hong Kong (Readers 5022, 5023, 5422 and 5427 G2)
(No specific text provided for Hong Kong in the excerpt)
India (Readers 5022, 5023, 5422 and 5427 G2)
(No specific text provided for India in the excerpt)
Japan MIC (Reader 4121)
この装置は総務省の型式指定を受けています。本製品は電波を使用したRFID機器の読み取り・書き込み装置です。そのため使用する用途・場所によっては、医療機器に影響を与える恐れがあります。
Korean KC (Readers 1021, 3121, 4040, 4321, 5021, 5022, 5325, 5326, 5421, 5422, 5427, 5427 G2, 6121, 6221, 6321)
| 항목 | 규격 | 항목 | 규격 |
| 송선수파수 | RFID:13.56 MHz | 전파형식 | A1D |
| 수선수파수 | RFID:13.56 MHz | 방선방식 | X-tal |
| 출력 | RFID: 10m에서 24.19m/h하 | 변조방식 | AM |
| 전원 | DC 5 |
Mexico (Readers 5022, 5023, 5422, 5427 G2)
(No specific text provided for Mexico in the excerpt)
Singapore (Reader 5427 CK)
Complies with IDA Standards DA103548
Taiwan (Readers 5321 and 5421)
総型式認證合格之低功率射頻電機, 非經許可, 公司、商號或使用者均不得擅自變更頻率、加大功率或變更產效計之特性及功能。低功率射頻電機之使用不得影響飛航安全及干擾合法通信。經發飛有干擾現象時,應立即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
According to "Administrative Regulations on Low Power Radio Waves Radiated Devices" Without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting power or alter original characteristic as well as performance to an approved low power radio-frequency devices shall not influence aircraft security and interfere legal communications; if found, the user shall cease operating immediately until no interference is achieved. The said legal communications means radio communications is operated in compliance with the Telecommunications Act.
The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM radio wave radiated devices.
