Dynalite | Philips lighting
Instruction Manual for PHILIPS models including: PDEB, Ethernet Bridge
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice – This equipment has been tested and found to comply with the
File Info : application/pdf, 2 Pages, 977.38KB
DocumentDocumentPDEB Ethernet Bridge Installation Instructions Instructions d'installation Installationsanweisungen Instrucciones de instalación Istruzioni per l'installazione Installatie-instructies Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. Les appareils doivent être installés par un électricien diplômé conformément à tous les codes et réglementations électriques et de construction nationaux et locaux. Die Geräte sind von einem qualifizierten Elektriker in Übereinstimmung mit allen geltenden Vorschriften zu installieren. Los dispositivos deben ser instalados por un electricista calificado y cumpliendo todas las normas y regulaciones, tanto nacionales como locales, sobre instalaciones eléctricas y obras. I dispositivi devono essere installati da un elettricista qualificato in conformità con le norme locali e nazionali vigenti in materia di costruzioni edilizie e installazione di impianti elettrici. De apparaten moeten worden aangebracht door een gekwalificeerde elektricien en in overeenstemming met alle nationale en plaatselijke elektriciteits- en bouwvoorschriften. / . 38 mm (1.49 in) PDEB X 4 106 mm (4.17 in) + V 1 A 110 mm (4.33 in) 45 mm (1.77 in) 99 mm (3.89 in) B IEC Pollution Degree II 45 mm (1.77 in) 1 ¡ ¢ £¤¥¥¡ ¦§ -20° C (-4° F) 90% www.lighting.philips.com/dynalite 2A GND AUX < 20 m ETHERNET SUPPLY IN 12/24 VDC -+ PDEB DYNET SHD GND D+ D+V AUX RJ12 SERVICE SHLD GND D+ D+V 2B Ethernet RJ45 12-24 V RJ12 2 A RS-485 DyNet ETHERNET SUPPLY IN 12/24 VDC -+ PDEB DYNET SHD GND D+ D+V AUX RJ12 SERVICE Ethernet RJ45 4 GND AUX < 20 m 12-24 V 5 3A + SHLD GND D + D - + V 12 V 24 V 100 mA 50 mA AUX µP SELV/Class 2 RJ12 RS-485 DyNet Port IEC Overvoltage Category III 3B Ethernet RJ45 - 12 V ¨©© + ( © SHLD GND D + D - + V ( ©© ©© AUX µP SELV/Cla RJ12 RS-485 DyNet Port IEC Overvoltage Category III Ethernet RJ45 Ethernet DyNet RS-485 Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any modifications not approved by the manufacturer of this device could void the user's authority to operate this device. Installation of a home and building automation and control system shall comply with HD 60364-4-41. The temperature limits and current-carrying capacities for the communication wires specified in HD 384.5.523 shall not be exceeded. This Class B digital apparatus complies with Canadian ICES-003: CAN ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la norme NMB003 du Canada: CAN ICES-3(B)/NMB-3(B). Do not connect inputs to mains. © 2021 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners. www.lighting.philips.com/dynalite AZZ 483 0321 R14