Before Use
Please read this manual carefully before use. Only connect the appliance to an earthed wall socket. This appliance is for household use only. When using electrical appliances, basic safety precautions should always be followed to avoid fires, electric shocks, burns, or other injuries and damage. Read these operating and safety instructions carefully.
Important Safeguards
- Pay attention to the polarity when installing batteries.
- Place the product in a dry indoor environment. Do not use in high-temperature (over 45°C) or humid environments.
- To protect the motor, do not close or open the lid directly with other forces. The lid will close automatically after 5 seconds.
- This product uses 4-6 alkaline AA batteries, which can be used for approximately 4 months under normal usage conditions (based on 30 open/close cycles per day in a lab setting; actual usage may vary).
- If batteries are depleted or the product is unused for a long time, remove or replace them to prevent over-discharge or leakage.
- Keep the product away from heat, direct light, and wind to prevent accidental opening.
- Do not replace unauthorized components or attempt to repair the unit yourself.
Parts and Location
The sensor bin consists of the following parts:
- 1. Lid
- 2. Touch screen
- 3. Inner ring
- 4. Outer ring
- 5. Body
- 6. Switch ON/OFF
- 7. Battery compartments
- 8. Battery cover
- 9. Battery case
Product Instructions
- Remove the lid and inner ring.
- Place a garbage bag into the body, ensuring the bag's opening is around the outer ring.
- Place the inner ring back on, tucking the bag's opening into the body.
- Press the switch to the 'ON' position (indicated by '-') and place the lid onto the body.
Operating Mode
Auto Induction Mode
The lid opens automatically when you are within 10-25 cm of the touch screen. If you are closer than 10 cm, it may not be detected.
Delay Closing Mode
When the auto sensor is active and you are within the induction area, the lid remains open. After you leave the induction area, the lid will automatically close after a 5-second countdown.
Manual Open Mode
Lightly touch the 'OPEN' button; the lid opens immediately and stays open. To close manually, lightly touch the 'CLOSE' button. The sensor bin will then revert to auto induction mode. If the 'CLOSE' button is not touched, the lid will automatically close after 120 seconds in manual open mode.
Operational states are indicated by the touch screen: 'Auto induction' (lid opens automatically), '5 Seconds to close' (lid closes after a delay), and 'Strobe to change batteries' (indicator for battery status).
Malfunctions and Solutions
Malfunction: Lid fails to open
Solutions:
- Check if batteries are installed correctly and have good contact with the springs.
- Ensure the ON/OFF switch is turned on.
- Step away from the inductive area for 10 seconds and try again.
Malfunction: Lid fails to close
Solutions:
- Check for any obstructions or interference in the inductive area.
- The circuit may be damp. Turn off the switch, remove the lid, and place it in a ventilated area until dry before trying again.
Malfunction: Lid opens very slowly
Solutions:
- Batteries are low; replace them with new ones.
- If these solutions do not resolve the issue, please consult your local sales agency.
Disposal
Do not dispose of this device with normal household waste. Dispose of the device through a registered waste disposal firm or your local recycling facility. Please adhere to current regulations. If in doubt, contact your nearest waste disposal facility.
Warranty
Dear Valued Customer, Thank you for purchasing a MOA product. This product is covered by a warranty that complies with all legal provisions concerning existing warranty and consumer rights in the country where the product was purchased. Should you find any defect or malfunction with your MOA product, please contact the appropriate Customer Care Center. Sincerely, The MOA Team
MOA
