Metsys ML360 / ML360G Manual

The ML360 series generates continuous 360-degree planes of laser light. A horizontal plane is ideal for ceiling and height-transfer applications, while two vertical planes, 90 degrees apart, provide all the reference needed for indoor tasks.

• High-quality laser beams ensure visibility. Green LD withstands hot/cold environments at any job site.
• The 2600 mAh Lithium-ion battery system provides satisfactory battery performance and savings on battery costs.
• Robust design with over-mold housing and alloy topping ensures the lasers can perform well even after minor accidents.
• The included magnetic bracket and clamp allow the laser to be used for various applications, such as ceiling and drywall installation.
• The LS1 Receiver and fine adjustment base are optional accessories to the standard kit. The LS1 receiver can be added for outdoor short-range applications, and the fine adjustment base is ideal for precise pinpoint indoor applications.
• The laser unit is classified as a Class II laser.
• Be careful not to expose your eyes to the laser beam while the instrument is operating.
• Direct exposure to the laser beam for a long time may be hazardous to your eyes.
• Do not attempt to dismantle the instrument. Only allow this to be done by your local Metsys service center.

Operation

When the unit is not in use, the pendulum should always be in the Off position. Locking the pendulum allows the Laser unit to better withstand vibration and trauma incurred during transportation or if the unit is dropped.

To use the laser in leveling mode, push the main switch button to the Unlock position. The horizontal plane will be activated. Press the laser selection on the control panel to activate the other two vertical beams. Each laser plane can be individually selected. To use with a laser detector, press the pulse button to activate this function.

Trouble Shooting

Solutions

• Check the batteries: they may be in the wrong way or need replacing. Check the battery compartment for signs of damage; ensure they are clean and not bent.
• Check the batteries: check the compartment for signs of damage and make sure they are clean and not bent.
• Instrument may be outside its self-leveling range: adjust the instrument or tripod so it is level. The instrument may have low power or impact damage.

Error

• Laser doesn't turn on
• Laser doesn't remain on for long periods of use.
• Laser doesn't self-level

Product Specifications

Product Inclusions

• 1x ML360/360G Laser tool
• 1x Magnetic ceiling bracket
• Clamp for drywall application
• 1x Magnetic laser Target
• Visibility enhancement glasses
• Injection carry case
• 1x Charger

Optional Extras

• LS1 detector
• Fine adjustment base
• 1.5m Tripod

Warranty

All Metsys line lasers have the ability for an Extended warranty (1 year). Standard warranty on these lasers is 1 year. Total with Extended warranty claimed is 2 years.

Receiver (LS1) Operation

1. Switch the LS1 (detector / receiver) on by pressing the power button; the speaker will beep indicating the instrument is operating.
2. Move the receiver / detector into the path of the laser beam.
3. Hold the detector upright for horizontal beams, rotate the receiver / detector 90 degrees for vertical beams.

Note: The LED direction indicators will indicate the position of the laser beam; the center LED will indicate alignment with the beam.

Function

Select this symbol / Button to activate the Pulse Mode for the ML360 Series to use the LS1.

Symbol

[Pulse symbol]

Contact Us

Address

14 STEPHENSON ROAD, BAYSWATER NORTH, VICTORIA 3153

Phone

03 9720 6222

Email

support@metsys.com.au

Product Designer

Justin Davis

Purchase Online

www.lightwavetechnology.com.au

Extended Warranty Submissions

http://www.metsys.com.au/warranty/4594309423

Follow Us

• METSYS_LASERS [Instagram icon]
• @METSYSLASERS [Facebook icon]