LED HIGH BAY

Safety Instructions

⚠️ WARNING

Please follow all safety instructions during installation and operation. Failure to do so may result in electric shock or damage to the product.

? CAUTION

Handle the product with care. Ensure proper ventilation.

Installation Instructions

This section provides guidance for the installation of the LED High Bay light.

Tools Required

The following tools are typically required for installation:

• Screwdriver
• Wire strippers
• Pliers
• Voltage tester
• Ladder or lifting equipment

Package Content

The package typically includes:

• LED fixture
• Mounting hardware (may vary)
• User manual

Note: Motion sensor is sold separately.

Installation Steps

1. Power Off: Always turn off the power supply at the circuit breaker before beginning installation. Verify power is off using a voltage tester.
2. Mounting: Securely mount the LED fixture according to the specific mounting instructions provided with the hardware. This may involve hanging chains or direct mounting.
3. Wiring: Connect the fixture's wiring to the power source following the General Wiring Diagram. Ensure all connections are secure and properly insulated.
4. Sensor Installation (if applicable): If a motion sensor is used, install it separately according to its own instructions.
5. Final Check: Ensure all connections are secure and the fixture is properly mounted.
6. Power On: Restore power to the circuit breaker. Test the fixture.

The installation is completed.

General Wiring Diagram Description

The wiring diagram illustrates the connections for a typical installation:

• Power Input: Connects to a 120-277V AC power source. Typically involves Black (Line), White (Neutral), and Green/Yellow (Ground) wires.
• LED Driver: The driver converts the AC power to the DC voltage required by the LED module.
• Dimming Control: For dimmable models, connect the 0-10V dimming wires to a compatible dimmer control system.
• LED Load: The internal LED light source.
• Conduit: Flexible metallic conduit may be used to protect wiring.

Diagram Description: A simplified schematic showing the flow of electricity from the power source through the LED driver to the LED light source, with connections for dimming control.

Warranty Information

This product is warranted for 5 years from the date of purchase. If this product does not perform to the specifications supplied on this package, send an email to support@runbisonlighting.com for product return and replacement. This replacement is the sole remedy available. Liability for incidental or consequential damage is expressly excluded.