BEGA 22613 Wall Luminaire

Application

Shielded wall luminaire with high protection class for a variety of lighting tasks. A luminaire made of die cast aluminium and impact resistant crystal glass with light diffusing structures.

Dimensions: Height: 90 mm, Width: 280 mm, Depth: 160 mm. Mounting hole spacing: 90 mm (75 mm + 25 mm). Cable entry diameter: 7-10.5 mm. Base dimensions: 60 mm x 135 mm. Mounting hole diameter: Ø 5.3 mm.

Product Description

• Construction: Aluminium alloy and stainless steel.
• Coating Technology: BEGA Unidure®.
• Glass: Crystal glass with optical structure.
• Mounting: 2 mounting holes Ø 5.3 mm, 90 mm apart.
• Cable Entry: 2 cable entries for through-wiring of mains supply cable, Ø 7-10.5 mm.
• Terminal: 2.5 mm² connection terminal.
• Earth Connection: Provided.
• Lampholder: E 27.
• Safety Class: I.
• Protection Class: IP 65 (Dust-tight and protection against water jets).
• Impact Strength: IK07 (Protection against mechanical impacts < 2 joule).
• Certification: CE - Conformity mark [Conformity mark].
• Weight: 2.5 kg.

Safety

The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Lamps / Light Source

• Luminaire Base: E 27 screw base.
• Maximum Lamp Output: 2 x 60 W.
• Product Energy Efficiency Classes: E, F.
• Supplied Lamp: 2 x BEGA LED lamp 13584, LED Retrofit 7 W, 1610 lm, 3000 K.
• Luminaire Efficiency: 27%.
• Additional BEGA LED lamps available: 13586 LED 7 W, 805 lm, 3000 K, dimmable.

Detailed technical and lighting data for the lamps can be found in the data sheets on the BEGA website.

Installation

1. Undo screws.
2. Remove cover and glass with gasket.
3. Lead the mains supply cable through the cable entry into the luminaire back housing.
4. Note position of application of the luminaire [arrow down].
5. Fix luminaire back housing with enclosed or any other suitable fixing material onto the mounting surface.
6. It is absolutely essential to use the enclosed gaskets.
7. Make earth conductor connection.
8. Push silicone sleeves over the lines and make electrical connection.
9. Insert lamp.
10. Insert cover with glass and gasket.
11. Make sure that the gasket is in correct position.
12. Tighten screws evenly.

Relamping & Maintenance

• Disconnect the electrical installation.
• Open the luminaire and clean.
• Use only solvent-free cleaning agents.
• Change the lamp.
• Check the gasket and replace, if necessary.
• Close the luminaire.

For cleaning, do not use high pressure cleaners.

Spares