Instruction Manual for PRINCE CASTLE models including: WBTS0943, Tomato Saber 943-B Stainless Steel Stainless Steel 216mm
Prince Castle Tomato Saber 943-B Stainless Steel Stainless Steel 216mm (W) x 465mm (D) x 237mm (H) 943-B (Each)
OPERATING INSTRUCTIONS Tomato Saber Model No. 943 Series TABLE OF CONTENTS PAGE Installation ..................................................................... 2 Operating ....................................................................... 2 Cleaning ........................................................................ 3 Replacing Blades ......................................................... 3 Exploded View .............................................................. 4 Parts List ....................................................................... 4 Prince Castles Tomato Saber slicer is designed to precisely slice whole tomatoes. With the exclusive Perma-Tight disposable blade cartridge system, this unit never requires blade tightening or adjusting. Engineered for durability and long life, the Tomato Saber features self-lubricating bearings, a blade guard, and a contoured Tomato Pusher. The unit is shipped with a Tomato Catcher, Table Stop, and Tomato Core-It. PRODUCT SPECIFICATION Model No. 943-A 943-B 943-C 943-D 943-W Slice Size 3/16 (.48cm) 1/4 (.64cm) 3/8 (.95cm) 7/32 (.55cm) 3/16 (.48cm) LIMITED WARRANTY This product is warranted to be free from defects in material and/or workmanship for a period of two (2) years from date of original installation, not to exceed 30 months from date of shipment from our factory with the exception of the blade cartridge. Blade cartridge is warranted to be free from defects at time of delivery only. Any component which proves to be faulty in material and/or workmanship will be replaced or repaired (at the option of Prince Castle, Inc.) without cost to the customer for parts or labor. This warranty is subject to the following exceptions/ conditions: l Use of products other than tomatoes will void this warranty. l This equipment is portable; charges for on-location service (e.g., trip charges, mileage) are not included in the provisions of this warranty. l Damage caused by carelessness, neglect, and/ or abuse (e.g., dropping, tampering or altering parts), equipment damaged in shipment, by fire, flood or an act of God is not covered under this warranty. Printed in 1999 Prince Castle Inc. 355 East Kehoe Blvd. l Carol Stream, IL 60188 Tel: (630) 462-8800 l Fax: (630) 462-1460 Toll Free: 1-800-PCASTLE 943-500 INSTALLATION 1. After you have removed the Tomato Saber from the carton, inspect the unit for signs of damage. If there is damage to the unit: l Notify carrier within 24 hours after delivery. l Save carton and packing materials for inspection purposes. l Contact your local Prince Castle dealer or the Prince Castle Customer Sales Department at 1800-722-7853, if purchased directly, to arrange for a replacement to be sent. 2. Verify that all parts have been received. l Tomato Saber slicer and Perma-Tight blade cartridge. l Tomato Catcherneatly catches tomato slices. l Table Stop Assemblystabilizes unit for easier slicing. l Tomato Core-Iteasily removes cores before slicing. 3. Place slicer on prep table or flat surface. IMPORTANT: Use of the Table Stop is optional. OPERATION CAUTION: Blades are extremly sharp. Keep fingers away from blades. IMPORTANT: The Tomato Saber is designed to slice tomatoes only. Using it to slice other products will damage the slicer and void the warranty. 1. For best results, use fresh, ripe tomatoes. Tomatoes should not exceed 3-1/2 inches (.76cm) in diameter. 2. Core the tomato using Prince Castles Tomato Core-It. Make sure to remove the core completely. 3. While holding top handle with one hand, grasp round pusher handle with other hand, and pull carrier assembly all the way back. 4. Position tomato against Tomato Pusher with core figure 3 4. Attach Tomato Catcher to slicer by sliding bottom figure 1 side down. See figure 3. cutouts over knobs at far end of unit. See figure 1. IMPORTANT: Use of the Tomato Catcher is optional. 5. Attach Table Stop by first removing two knobs from the operator end of slicer. Align the two holes of Table Stop with the holes in the base of the slicer. Reattach the two previously removed knobs over the Table Stop. See figure 2. figure 2 5. While holding bridge with one hand, grasp round pusher handle with other hand. Push tomato completely through blades with ONE QUICK, FIRM figure 4 STROKE until the pusher head stops. See figure 4. 2 6. After tomato has been sliced, remove tomato slices 5. Let air dry. from Tomato Catcher. CLEANING REPLACING BLADES CAUTION: Blades are extremly sharp. Keep fingers away from blades. IMPORTANT: The Tomato Saber must be cleaned after each use. 1. Grasp round, red handle and pull carrier assembly all the way back. 2. While holding the bridge with one hand, firmly grasp the blade cartridge by the finger grip with 1. Remove Tomato Catcher and Table Stop to clean separately. Note: Do not remove Perma-Tight blade cartridge from unit. 2. Spray slicer with hot water to remove any tomato residue. 3. With hot, soapy water, scrub Tomato Pusher using a nylon brush. With same brush, clean blades from back side. 4. Rinse unit with hot water. figure 5 other hand. Pull the blade cartridge all the way out. The blade clip will release the cartridge. See figure 5. figure 6 3. Slide in the new blade cartridge with arrow facing up. See figure 6. figure 7 4. Firmly push the blade cartridge into place until it snaps into the blade clip . See figure 7. 5. Properly discard the old blade cartridge using the packaging from new blade cartridge. 3 EXPLODED VIEW 1 5 6 4 3 2 7 8 9 11 12 10 13 14 15 PARTS LIST ITEM 1 2 3 4 5 PART NO. DESCRIPTION 943-038A Blade Assy. 3/16 (0.48 cm) 943-039A Blade Assy. 1/4 (0.64 cm) ITEM 6 7 943-040A Blade Assy. 3/8 (0.95 cm) 8 943-041A Blade Assy. 7/32 (0.55 cm) 9 943-047S Table Stop w/Knobs 10 76-626S Knobs (Pkg. Of 2) 11 943-049S Pusher Handle w/Mounting Screw 12 943-050 Tomato Pusher Assy. 13 3/ 16 & 3/8 (0.48 cm & 0.95 cm) 14 943-050WC Tomato Pusher Assy. 3/16 15 (For 943-W Only) 943-051 Tomato Pusher Assy. 1/4 (0.64 cm) 943-052 Tomato Pusher Assy. 7/32 (0.55 cm) . 943-004S Bridge w/Mounting Screws 4 PART NO. 943-018S 943-033S 943-012 943-002 89-959S 943-034S 943-006S 943-017S 919-17S 943-016 DESCRIPTION Tomato Catcher Guide Rod Knobs (Pkg. of 2) Blade Guard Base Rubber Foot (Pkg. of 4) Blade Latch Kit Carriage with Bearings Guide Rods w/Cushions (Set of 2) Guide Rod Cushions (Pkg. of 4) Carriage PlateAcrobat Distiller 4.05 for Windows