User Manual for OPTONICA models including: LED Street Light, Street Light, Light
LED Street Light SANAN-Chip 75x130° 3 Year Warrant | OptonicaLED
1 day ago — If in any doubt, consult a qualified electrician. FIXING INSTRUCTIONS. Do not wire this fliidlight into the lighting circuit - use a switched fused spur. This ...
USER MANUAL LED STREET LIGHT Please take time to read this leaflet carefully and retain it for future reference. DIAGRAM Photocell Sensor: The light will turn on when the sensor detects no light, and turn off when the sensor detects light. Bolts ADC#12 Aluminum Alloy PC Lens H05RN-3G0.75mm² IMPORTANT SAFETY INFORMATION - Do not wire this floodlight into the lighting circuit - use a switched fused spur. - Before installation and servicingm disconnect the electrical supply at the mains. - Carefully observe all instructions or warnings that are labelled on, or supplied withm your product. - This product is suitable for outdoor use. If in any doubt, consult a qualified electrician. FIXING INSTRUCTIONS Do not wire this fliidlight into the lighting circuit - use a switched fused spur. This fitting must be earthed, concatc a qualified electrician to install a suitable earth facility. Ensure the electricity is turned off at the mains before installing or maintaining any electrical fitting. NOTE For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mounting point for this product, before proceeding with the installation. GENERAL INFORMATION Do not mount ceiling/wall fittings onto damp surfaces such as newly painted or pleastered areas as this may cause discolouration of the finish. Tolls which may be required: - Drill - Cross Head Screwdriver - Small Electrical Slotted Screwdriver - Insulation Tape INSTALLATION Note: before installation. Only use a round cable supplied to connect this fitting. (6mm Diameter minimum.) 1. Fasten the adjustable bracket with stainless steel screws. This is required in order to create a good water seal when connected to the fitting. 2. Connect the Main Line to the power wire of the lamp 3. Ensure the terminal connection is made inside a suitable IP65 rated junction box. (not included) From Floodlight From IP65 Rated Junction Box 4. Install the LED street lights in the pole and wall. This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. (Waste Electriacal ane Eceltronic Equipment Directive) IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;Corel PDF Engine Version 24.0.0.301