Anko Instruction Manual

Product Image Description: A handheld wet and dry vacuum cleaner with various attachments. The main body is black and features a dust collector, HEPA filter, dust entrance, and an air outlet. A switch button is located on top, with a button to open the dust collector. Accessories include a brush attachment for sucking up small debris, a flat nozzle for corners, and a power cord with a cigarette lighter plug.

Specification

• Power Source: DC12V 5A Max
• Suction Power: 4-4.5kPa
• Motor rating: 60W
• Cord length: 4.2m

Operation Instructions

1. Start the car or other 12V DC power supply equipment.
2. Plug the power cord plug into the cigarette lighter.
3. Select a suitable vacuum cleaner suction nozzle according to the user environment.
4. Handle the vacuum cleaner, push forward the power switch to start the vacuum cleaner and begin cleaning.
5. After use, push the switch back to stop the vacuum cleaner. Press the dust collection button and remove the dust cover to take out the filter. Shake off the dust or rinse with water. It uses a HEPA filter, which needs to dry out completely after cleaning. DO NOT immerse the motor in water.
6. Collect the power lines and vacuum cleaner to finish the vacuum cleaning operation.

Attention

• Do not block the heating dissipating hole or suction outlets during use.
• Never dismantle the product without authorization, as this may void the warranty.
• The dry and wet application can quickly suck up dry matter and small amounts of liquid inside the car (except corrosive, flammable, and explosive liquids). Do not expose this unit to rain.
• Make sure the HEPA filter is properly installed before use. The HEPA filter needs to be cleaned after every use and dried completely.
• Do not use near heaters or in high-temperature locations.
• Allow a 10-minute rest period after every 20 minutes of continuous operation to prevent motor overheating.

Fuse Replacement

This appliance is fitted with a 10A fuse located in the cigarette lighter plug. Should the fuse need replacing, unscrew the end cap and replace it with an equivalent fuse.

Caution: For continued protection against the risk of fire, the replacement fuse should be the same type and rating as the original fuse.

DO NOT vacuum up lit cigarette butts, as this may cause fires or damage the filter.

This product is not intended for commercial or industrial use.

12 Month Warranty

Thank you for your purchase from Kmart.

Kmart Australia Ltd warrants this new product to be free from defects in materials and workmanship for a period of 12 months from the date of purchase, provided it is used in accordance with the accompanying recommendations or instructions. This warranty is in addition to your rights under the Australian Consumer Law.

Kmart will provide a refund, repair, or exchange (where possible) for this product if it becomes defective within the warranty period. Kmart will cover reasonable expenses for warranty claims. This warranty will not apply if the defect results from alteration, accident, misuse, abuse, or neglect.

Please retain your receipt as proof of purchase. For assistance, contact Kmart Customer Service on 1800 124 125 (Australia) or 0800 945 995 (New Zealand), or visit Kmart.com.au. Warranty claims and claims for expenses incurred in returning this product can be sent to our Customer Service Centre at 690 Springvale Rd, Mulgrave Vic 3170.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand legislation.