Frigidaire Beverage Center Use & Care

Using Your Beverage Center

Startup

Connect the power cord to a standard wall outlet. You will hear a beep upon connection. Do not use a GFCI outlet.

Temperature - Adjustable Thermostat Control

The default temperature is 43°F. Use the up ⬆️ and down ⬇️ buttons to set the desired temperature between 40°F and 61°F. The display will flash during adjustment and then show the current internal temperature. Pressing the up or down buttons again will display the selected temperature setting. The unit will revert to the last setting after a power outage.

Loading Beverages

For optimal cooling of a large number of beverages:

1. Set the thermostat to 43°F.
2. Allow the unit to cool for at least two hours.
3. Load beverages, referring to loading diagrams for maximum capacity.
4. The internal temperature may rise initially after loading.
5. Once cooled to 43°F, adjust to your desired temperature (minimum 40°F).
6. Allow several hours for the unit to reach the lower temperature.

Note: Temperature variations are normal; areas near the door may be slightly warmer.

Loading Diagrams

Standard 12 Ounce Cans: Accommodates 126 cans. Position shelves and load as shown:

• ROW 1: 30 cans (Upright)
• ROW 2: 30 cans (Upright)
• ROW 3: 18 cans (Laying Down)
• ROW 4: 24 cans (Upright)
• ROW 5: 24 cans (Upright)

Bottles: Capacity varies by shelf position and bottle width. Nest bottles for greater capacity.

Other Beverages: Shelves are adjustable for various can and bottle sizes.

Defrosting

LED Light

Press the ? button to turn the LED light on and off. Use the light primarily for loading and selecting beverages to prolong its life and conserve energy.

Shutdown

For long-term storage, unplug the unit, clean it thoroughly, and leave the door slightly ajar to prevent mildew.

Safety Warnings

• This appliance is not intended for use by unsupervised children or infirm persons.
• Do not position in a recessed or enclosed cabinet; designed for freestanding installation only. Not for RV, garage, or outdoor use.
• The compressor surface can get hot; do not touch.

Other Dangers

Keep the unit away from combustible or volatile liquids and gases (gasoline, oil, alcohol, paint, paint thinners, solvents).

Defrosting

Frost may develop on the interior back panel if the temperature is set very low and the unit is not fully stocked. This can cause continuous operation and increase internal temperature.

To defrost:

1. Use the up ⬆️ and down ⬇️ buttons to increase the temperature until the compressor turns off.
2. Allow frost to melt. Ensure the internal drain (at the middle back of the lower shelf) is not clogged. Melted frost flows to a pan on top of the compressor, where heat evaporates the liquid.
3. Reset the temperature to 43°F and allow to cool for at least one hour.
4. Adjust to the desired temperature setting.

Cleaning and Maintenance

Periodically clean and maintain the beverage center. Ensure the unit is unplugged before maintenance.

Wipe interior and exterior surfaces with a damp cloth. Use mild detergent or baking soda and water solution if needed. Rinse with clean water and dry with a soft cloth. A kitchen appliance wax can be applied to outer surfaces.

Inspect, clean, and maintain the rubber gasket. A small amount of petroleum jelly on the gasket's bracket side will keep it pliable and ensure a good seal.

IMPORTANT:

• Do not use hot water, harsh detergents, gasoline, kerosene, solvents, acids, or flammable materials.
• Do not spray the unit with water.
• Do not clean glass shelves with hot water when cold.
• Obtain replacement components only from Frigidaire Customer Service.

LED Light Replacement

TOOLS NEEDED: Phillips screwdriver, flashlight.

If the LED light is not illuminating, it may need replacement. Replacement lights are available from Customer Service.

Removing the Existing LED Light:

1. Unplug the beverage center.
2. Using a Phillips screwdriver, remove the two screws from the clear plastic cover.
3. Tilt the panel forward and unscrew the LED board from the black plastic spacer.
4. Gently unclip the power cable from the red socket insert on the LED board.

Installing the Replacement LED Light:

• Insert the power cable into the red socket insert on the new LED board.
• Position the board within the black plastic spacer.
• Reassemble the LED board, spacer, and cover using the two screws.
• Tuck the cable into the wire slot.
• Reposition the panel and enclose the cord within the LED housing.
• Reattach the clear plastic panel with two screws.

Troubleshooting

Safety Warnings

Read this owner's manual carefully before using your beverage center. Use only for its intended purpose.

Child Entrapment Danger

• Before disposing of an old refrigerator or freezer, remove the doors and leave shelves in place to deter children from climbing inside.

Installation and Grounding

• The appliance must be correctly installed and connected to power according to installation instructions.
• The main power supply must be properly grounded.
• Ensure the plug is accessible. Never pull the unit by the power cord; grasp the plug firmly.
• Do not use an extension cord.

Transport and Handling

• Keep the unit upright during transport. Do not tilt beyond 45° or place upside down.
• Do not touch cold surfaces with wet hands.
• Position the unit away from combustible sources (gas, petrol, alcohol, lacquer, banana oil). Do not store these items inside.
• If the unit fails to cool, dispose of spoiled food.
• Unplug before cleaning or repairs. Repairs should be performed by qualified technicians; unqualified repairs void the warranty.
• Do not use electrical devices (e.g., hair dryer) to defrost. Do not scrape ice with sharp tools, as this can damage the refrigerant circuit.
• The rating plate is located inside or on the rear/side wall.
• This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience, unless supervised. Supervise children to ensure they do not play with the appliance.
• Do not run the cord over carpeting or other heat insulators. Keep the cord away from traffic areas and do not submerge it in water. If the cord is damaged, it must be replaced by the manufacturer, service agent, or a similarly qualified person. Replace frayed or damaged cords immediately.
• Do not operate in the presence of explosive fumes.
• Do not use flammable materials on or near the unit, as this can cause fire and damage.
• DANGER – Risk of Fire or Explosion: Flammable refrigerant used. Repair only by trained service personnel. Do not puncture refrigerant tubing.
• CAUTION – Risk of Fire or Explosion: Dispose of property according to regulations. Flammable refrigerant used. Consult repair manual/owner's guide before servicing. Follow all safety precautions.
• CAUTION – Risk of Fire or Explosion due to Puncture of Refrigerant Tubing: Follow handling instructions carefully. Flammable refrigerant used.

Disposal

• Remove the door before disposing of the unit. Leave shelves inside to prevent children from climbing in and becoming trapped or suffocating.

Product Specifications

• Capacity: 4.4 cu ft
• Shelf Material: Glass
• Temperature Control Type: Electronic Temperature Control
• Temperature Range: 40°F - 61°F / 4°C - 16°C
• Dimensions (Inches):
• Depth (excluding handles): 21.25
• Depth (including handles): 22.72
• Depth (less door): 19.02
• Depth with door open 90 degrees: 40.31
• Height to top of door hinge: 31.22
• Product Depth: 21.25
• Product Height: 31.38
• Product Width: 20.50

Limited Warranty

Warranty Period: 1 Year from the date of original purchase.

To Make a Warranty Claim: Do not return to store. Email support@curtiscs.com or call 1-800-968-9853.

This warranty covers defects in material and workmanship. Your sole remedy is repair or replacement at Frigidaire's option. You are responsible for return shipping costs. If the product or component is unavailable, it will be replaced with a similar item of equal or greater value.

Warranty Exclusions: This warranty does not cover glass, filters, normal wear, use not in conformity with printed directions, damage from accident, alteration, abuse, or misuse. It extends only to the original consumer purchaser. Proof of purchase (original sales receipt) is required.

This warranty is void if the product is used for other than single-family household use or subjected to incorrect voltage/waveform (e.g., 120V~60Hz).

Frigidaire disclaims liability for special, incidental, and consequential damages. Liability is limited to the purchase price. Implied warranties are limited to the duration of this written warranty, to the extent permitted by law. You may have other legal rights that vary by state or province.

For faster service, locate the model, type, and serial numbers on your appliance.

Contact Information:

• Email: support@curtiscs.com
• Phone: 1-800-968-9853

Manufacturer Address:

CURTIS INTERNATIONAL LTD
7045 BECKETT DRIVE, UNIT 15
MISSISSAUGA, ONTARIO
L5S 2A3