User Guide for PHILLIPS models including: Hello App, App
Phillips Industries TTP01 Phillips T/T Pair 2BG6P-TTP01 2BG6PTTP01 ttp01
Front T/T Pair Installation Instructions: 1). Remove old QCS socket from socket. 2). Install T/T pair with NEW bolts enclosed. 3). Scan QR Code below to download Free IoS or Android install App. IOS Android Back Basic Warranty Policy: Phillips Industries offers a Limited Warranty to the original purchaser that the warranted products are free from defects in workmanship and/or materials only. Charges for additional incidental or consequential damage, including labor costs, cannot be accepted. Phillips' policy is to replace the warranted product to the original purchaser if the product fails because of a defect due to workmanship and/or materials within the limited warranty period from the original production date. Warranties are not transferable and apply only to the original owner of the Phillips product. Product Warranty Time Limits All products receive a warranty time period of 1 year. Phillips USA 5231 California Avenue, Suite 220 Irvine, CA 92617 Phone: 800-423-4512 Fax: 800-597-7757 FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. IC STATEMENT This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. In order to avoid the possibility of exceeding the IC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation. Afin d'éviter la possibilité de dépasser les limites d'exposition aux fréquences radio de la IC CNR102, la proximité humaine à l'antenne ne doit pas être inférieure à 20 cm (8 pouces) pendant le fonctionnement normal.Microsoft PowerPoint 适用于 Microsoft 365