Instruction Manual for PHILIPS models including: DMRC210 Relay Controller, DMRC210, Relay Controller, Controller
2 giorni fa — I dispositivi devono essere installati da un elettricista qualificato in conformità con le norme locali e nazionali vigenti in materia di costruzioni.
File Info : application/pdf, 2 Pages, 1,013.02KB
DocumentDocumentDMRC210 Relay Controller Installation Instructions Instructions d'installation Installationsanweisungen Instrucciones de instalación Istruzioni per l'installazione Installatie-instructies Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. Les appareils doivent être installés par un électricien diplômé conformément à tous les codes et réglementations électriques et de construction nationaux et locaux. Die Geräte sind von einem qualifizierten Elektriker in Übereinstimmung mit allen geltenden Vorschriften zu installieren. Los dispositivos deben ser instalados por un electricista calificado y cumpliendo todas las normas y regulaciones, tanto nacionales como locales, sobre instalaciones eléctricas y obras. I dispositivi devono essere installati da un elettricista qualificato in conformità con le norme locali e nazionali vigenti in materia di costruzioni edilizie e installazione di impianti elettrici. De apparaten moeten worden aangebracht door een gekwalificeerde elektricien en in overeenstemming met alle nationale en plaatselijke elektriciteits- en bouwvoorschriften. / . 230 mm (9.05 in) X 2 38 mm (1.49 in) 240 mm (9.44 in) 45 mm (1.77 in) 1 2 1 ¡ ¢ £¤¥¥¡ ¦§ ¡ ¢ £0¥¡ ¦§ 90% 3 30 mm (1.18 in) 30 mm (1.18 in) 30 mm (1.18 in) IEC Pollution Degree II 30 mm (1.18 in) 4 Output Ratings/Channel (CH) Load Type General Use Incandescent Electronic Ballast Inrush Current Output Ratings/Group DMRC210 20 A CH1-CH2 10 A, 240 V 5 A, 240 V 3 A, 240 V 165 A 5 100-240 V 20 A Lin Lout2 Lout1 N µP N IEC Overvoltage Category III RS-485 DyNet +12 V D D + GND SHLD 12 V 150 mA SELV/ Class 2 (UL) N 6 20A 5 mm2 0.3-2.5 mm2 10+ AWG 0.62 Nm 5.5 Lb-in Lin Lout2 Lout1 N N 22-12 AWG 0.4 Nm 3.5 Lb-in +12 V D- D+ GND SHLD RS-485 DyNet 2 A S hield 7 8 RS-485 DyNet 9 © 2022 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners. www.dynalite.com AZZ 381 0922 R15