Philips Hue Xamento

What's Included

• Main fixture (A)
• Accessories (B)

What's Excluded

• [Drill]
• [Hole Saw] (recommended size: 70-75 mm)
• [Pencil]
• [Screwdrivers] (Phillips and flathead)

Safety and Preparation

⚠️ Important Safety Information: Ensure the power supply is turned OFF before installation.

Installation Preparation:

• Mark the ceiling and drill a hole with a diameter of 70-75 mm using a hole saw.
• Ensure adequate clearance behind the fixture: minimum 100 mm total clearance. Specific clearances required are 'a': Min. 10 cm, and 'b': Min. 30 cm.

Installation Steps

1. Insert the fixture into the prepared ceiling cutout.
2. Secure the fixture in place using the integrated spring clips. [Arrows indicating clips closing]
3. Open the connector block. [Arrow indicating opening]
4. Insert the power supply cables into the appropriate terminals within the connector block. [Arrows indicating cable insertion]
5. Close and secure the connector block cover. [Arrow indicating closing]
6. Install the GU10 bulb (maximum 6W) into the fixture's socket. [Arrow indicating bulb insertion and rotation]
7. Connect the bulb to the fixture's wiring.
8. Ensure the fixture is securely mounted in the ceiling. [Arrow indicating insertion]

Technical Specifications

• Ingress Protection: IP20 (indoor use), IP44 (suitable for bathrooms, splash-proof)
• Bulb Type: GU10
• Maximum Wattage: MAX. 6 W

Power On and Usage

Turn the power supply ON.

For detailed setup and usage instructions, refer to the Quick Start Guide and visit www.philips-hue.com.

❓ For assistance, visit www.philips-hue.com.