CRTECH LED Flush Mounts

Important Warnings

WARNING: Installation must be performed by a qualified electrician.

• LED Ceiling Mounts are suitable for damp locations.
• Keep away from corrosive substances. Clean with a dry cloth.
• Installation requires a qualified electrician.
• Disconnect power before installation or maintenance to prevent electric shock.

Application Notice

• Installation must be done by a licensed electrician or technician with electrical knowledge and understanding of safety requirements.
• Operate only with the voltage and frequency stated in this manual. Different voltage/frequency may affect product lifespan.
• Power MUST be turned OFF during installation and servicing. For indoor use only.

Caution

Please read these instructions before installation and keep them for future reference. Electrical products can cause death, injury, or property damage. If in doubt, consult a competent electrician.

Installation Guide

Assembly Instructions

1. Turn off the power.
2. Rotate the ACRYLIC LENS (11) counterclockwise to remove it.
3. Pull the SUPPLY WIRES (3 & 4) and HOUSE GROUND WIRE (2) out from the OUTLET BOX (1).
4. Make wiring connections: Connect the HOUSE GROUND WIRE (2) to the FIXTURE GROUND WIRE (6). Connect the WHITE SUPPLY WIRE (3) to the WHITE FIXTURE WIRE (7). Connect the BLACK SUPPLY WIRE (4) to the BLACK FIXTURE WIRE (8) using WIRE CONNECTORS (5). Thread one of the FIXTURE SCREWS (10) two full turns into the threaded hole on the OUTLET BOX (1). Carefully tuck all wires back into the OUTLET BOX (1).
5. Locate the FIXTURE PAN (9) over the OUTLET BOX (1). Position the MOUNTING SCREW (10) through the large opening of the keyhole slot and twist it to the narrow opening. Put the other MOUNTING SCREW (10) through the long slot on the FIXTURE PAN (9) and thread it into the OUTLET BOX (1). Secure the FIXTURE PAN (9) to the OUTLET BOX (1) by tightening the two MOUNTING SCREWS (10).
6. Rotate the LENS (11) clockwise onto the FIXTURE PAN (9) to complete the installation.

Parts Diagram and Identification

The diagram illustrates the components involved in the installation. The numbered parts are:

• (1) Outlet Box
• (2) House Ground Wire
• (3) White Supply Wire
• (4) Black Supply Wire
• (5) Wire Connectors
• (6) Fixture Ground Wire
• (7) White Fixture Wire
• (8) Black Fixture Wire
• (9) Fixture Pan
• (10) Mounting Screw
• (11) Lens

The diagram also shows color temperature indicators (2700K, 3000K, 3500K, 4000K, 5000K) which are not directly part of the assembly steps but are visual cues on the product itself.