Instruction Manual for Huajue models including: H13 Wireless Bluetooth Headset, H13, Wireless Bluetooth Headset, Bluetooth Headset, Headset
Shenzhen Huajue Communication Co., Ltd H13 2BB5Y-H13 2BB5YH13 h13
il y a 1 jour — ... earbuds, and automatically turn on and pair automatically. 2、L/R ear press and hold for 3 seconds (in the shutdown state). 1、After the earphone L/R is ...
) aNNa(a 1.1 2.L/R35 3 3. H13 4.55 1L/R 2L/R3() 1 L/R 2L/R5() 2L/R 2L/R 3L/R 23 / 2L/R 3L 3R 3R + 1R+ - 1L- LED / /1 50% 25% 75% 100% 11s 225% 25%25% 50% 50%50% 75%100% 100% 10s -25% 100% FCC151 2 FCC15B -- -- -- --/ RSS tasmittre/ / 1 2 ; IC Wireless bluetooth headset INSTRUCTION MANUAL How to connect 1. Please keep the distance between the Bluetooth headset and the mobile phone (or other connected devices) within 1 meter, the closer the better; 2. Open the lid of the charging case, take out the L/R headphones and automatically pair, the pairing time is 3~5 seconds, prompt slow flashing, wait Connect Bluetooth devices; If the pairing is not successful for 3 minutes, please turn off the computer. 3. Turn on the user's mobile phone Bluetooth function (or other Bluetooth devices), search or scan, at this time the mobile phone will search for nearby Bluetooth device, click on the searched headset name: H13, after successful connection, you can make a mobile phone call at this time, listen to songs; 4. After the phone and Bluetooth are successfully connected, the device will automatically shut down after 5 minutes of disconnection from a distance; If the headset is not connected for 5 minutes, the headset will automatically shut down. Touch area Earphone operation mode (power on and pairing) Boot up 1aOpen the lid of the charging case, take out the L/R earbuds, and automatically turn on and pair automatically 2aL/R ear press and hold for 3 seconds (in the shutdown state) Shut down 1aAfter the earphone L/R is placed in the charging case, it will automatically turn off 2a L/R ear press and hold for 5 seconds (in the power on state) and the device is invalid after connecting Earphone operation mode (call control) Call answer Press 2 times (L/R) on the touch area to answer the call Call hang up Press 2 times (L/R) to touch area to hang up the phone Incoming call rejection The ear lever long presses and holds for 3 seconds (L/R) to touch area to reject incoming calls Voice assistants Long press the ear handle on the left for 2~3s to enter the voice assistant Earphone operation mode (playing music) Play / Pause Press 2 times (L/R) on the touch area Previous piece Press 3 times (L) on the touch area Next track Press 3 times (R) on the touch area Game mode The ear lever long presses and holds for 3 seconds (R) to touch area cut-in game mode Volume + Press 1 time (R) on the touch area to vol+ Volume- Press 1 time (L) on the touch area to vol- Charging case LED screen indicator status indication Product status Headphones in/out of the charging case Indicator light definition The earphones enter / exit the charging case, and the corresponding power white light flashes 1 time each. Charging in the charging case 50% battery indicator 25% battery indicator 75% battery indicator 100% battery indicator Charging complete 1. Four white lights are on for 1s at the same time; 2. When charging a charging case with less than 25% power, the charging compartment indicator light is from left to leftThe right cycle flashes, when the power reaches 25%, the 25% power indicator is long, it will automatically jump to the 50% power indicator for charging, the charging compartment indicator flashes cyclically from left to right, when the power reaches 50%, the 50% power indicator is long; 75% charge and 100% charge are repeated in the above way, and the charging is cycled in turn. The charging compartment is 100% fully charged and four white lights are always on. The charging compartment closes the lid to charge the headphones The earphone is charged with the lid closed in the charging compartment, and the power white light is always on for 10s and turns off. Charging case low battery prompt Charging case full battery prompt The charging compartment battery is low - the corresponding 25% charge light flashes quickly. The charging compartment is 100% fully charged and four white lights are always on. Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. IC warning: This device contains licence-exempt tasmittre(s)/receiver(s)/ that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device. Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment; To maintain compliance with IC's RF Exposure guidelines, This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Déclaration de l'ISED Canada : Cet appareil contient des tasmittre (s) / récepteur (s) sans licence / conformes à l'innovationRSS exemptes de licence de Sciences et Développement économique Canada. L'opération est sous réserve des deux conditions suivantes : 1) cet appareil ne peut pas causer d'interférences et 2) ce dispositif doit accepter toute interférence, y compris peut provoquer le fonctionnement indésirable de l'appareil. Exposition aux rayonnements : Cet équipement est conforme aux radiations du Canada limites d'exposition pour un environnement incontrôlé noncé d'exposition RF Pour maintenir le respect des guides d'exposition RF d'IC, Cet appareil et ses antennes ne doivent pas être co-localisé ou en opération en conjonction avec toute autre antenne ou émetteur.Adobe PDF library 16.03