Sussex Taps – Making it right entirely in Australia since 1997
Installation Guide for SUSSEX models including: BEBM85 Calibre Basin Mixer, BEBM85, Calibre Basin Mixer, Basin Mixer, Mixer
File Info : application/pdf, 1 Pages, 345.31KB
DocumentDocumentSuba Basin mixer BASE O RING 1/2" BSP Fittings with conical Seals sussextaps.com.au 50mm Max. Bench thickness Hole Size 32-35mm CLAMP FIXING NUT FLEXIBLE HOSES Product code: CBM Product code BBM BEBM85 BEBM125 Basin mixer Extended basin mixer 85mm outlet Extended basin mixer 125mm outlet BLBM BLEBM85 BLEBM125 Lever basin mixer Lever extended basin mixer 85mm outlet Lever extended basin mixer 125mm outlet Installation guidelines - The Mixer is supplied assembled, only the Fixing nut and the Clamp need to be removed. - After removing the mentioned parts, lower the Mixer on to the mounting surface and fit the Flexible Hoses. - In some cases the Flexible Hoses may need to be fed through from under the mounting surface and then attached. (Tighten using appropriate spanner) - After securing the Flexible Hoses, fit Clamp and attach the Fixing Nut from underneath. - Before fully securing the Mixer ensure that the Base O Ring is intact and the Mixer is properly centered over the mounting surface hole. - The Mixer mounting surface must be completely sealed and water-tight. - The 1/2" Fittings of the Flexible Hoses have a conical seal, ensure that the matching threads are cut square and burr free. - Prior to connecting the Flexible Hoses, ensure all pipework is thoroughly flushed and ensure pipework is free of any dirt or debri. - Isolating Stop Valves are recommended with all installations. (not supplied) - Connect the Flexible Hoses to Hot and Cold pipework fittings, ensure the Hoses do not kink or become twisted when tightening. - Check all fittings and connections are secure and water-tight. Plumber note - On-site testing using higher water pressures must be conducted with the Mixer in the closed position. (STATIC TEST) - Under no circumstances is the Mixer to be opened when exceeding the maximum stated water pressure. - At the completion of testing, do not relieve any high water pressure by operating the Mixer. - Exposing the internals of the Mixer Car tridge to higher than specified water pressures will void the manufacturers warranty. AS/NZS 3718:2005 LIC. 20081 The more stars the more water efficient WATER RATING www.waterrating.gov.au 3.0 litres per minute In accordance with AS/NZS 6400 Licence No. 0124 Sussex Taps Pty Ltd Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003 Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c Copyright © Sussex Taps.