Carrera RC Audi R8 LMS GT3 evo II - Steam

Safety Instructions

Please observe the following safety regulations:

• A: Do not operate the vehicle in traffic.
• B: Do not operate the vehicle in sand or on loose surfaces.
• C: Do not operate the vehicle in rain, snow, or wet conditions.
• D: Avoid driving through water or puddles.
• E: Protect the vehicle from direct sunlight and extreme heat.
• F: Ensure correct battery installation and polarity.
• G: Always turn off the vehicle and remote control when not in use.
• H: Use the provided screwdriver for battery compartment access.

Multilingual Safety Information:

German: Sicherheitsbestimmungen

English: Safety instructions

French: Consignes de sécurité

Spanish: Disposiciones de seguridad

Italian: Norme di sicurezza

Dutch: Veiligheidsbepalingen

Portuguese: Prescrições de segurança

Swedish: Säkerhetsbestämmelser

Finnish: Turvallisuusohjeet

Polish: Zasady bezpieczeństwa

Hungarian: Biztonsági rendelkezések

Slovenian: Varnostna določila

Czech: Bezpečnostní předpisy

Slovak: Bezpečnostné predpisy

Greek: Διατάξεις ασφαλείας

Chinese: 安全准则

Korean: 안전수칙

Product Contents and Assembly

Package Contents:

• 1x Carrera RC Audi R8 LMS GT3 evo II - Steam vehicle
• 1x Remote Control Transmitter
• 4x Drift Tyres
• 2x 1.5 V Micro AAA Batteries (for transmitter)
• 6x 1.5V Mignon AA Batteries (for vehicle)

Step-by-Step Assembly and Operation:

1. Vehicle and Transmitter Setup: Ensure you have the correct batteries. The vehicle requires 6x 1.5V Mignon AA batteries, and the transmitter requires 2x 1.5 V Micro AAA batteries.
2. Installing Vehicle Batteries: Open the battery compartment on the underside of the vehicle. Insert 6x 1.5V Mignon AA batteries, observing the correct polarity (+/-). Close the compartment securely.
3. Installing Transmitter Batteries: Open the battery compartment on the remote control transmitter. Insert 2x 1.5 V Micro AAA batteries, observing the correct polarity (+/-). Close the compartment securely.
4. Powering On/Off: Locate the power switch on the underside of the vehicle. Slide it to the 'ON' position to power the vehicle. Slide to 'OFF' to power down.
5. Transmitter Controls: The transmitter features a steering wheel for left/right control and a trigger for forward/backward acceleration.
6. Antenna and Binding: Ensure the transmitter antenna is extended. The vehicle and transmitter are pre-bound for immediate use.
7. Operation: Use the steering wheel and trigger on the transmitter to control the movement of the RC car.
8. Battery Replacement: When performance decreases, replace the batteries in both the vehicle and the transmitter with fresh ones.

Note: The included batteries for the transmitter are 2x 1.5 V Micro AAA. The vehicle requires 6x 1.5V Mignon AA batteries, which are not included.

Manual Information: The remote control transmitter is a Carrera Toys GmbH Short Range Device - Remote Control Toy Transmitter (2.4GHz), model YFA370410537.