Instructions for ApplyLabWork models including: MPT-SP001BK, MSLA Spring Black, Spring Black, MSLA Spring, Spring
Prototype Engineering Series APPLYLABWORK PRINTING INSTRUCTIONS Post-curing (Mandatory): Submerge the parts into glycerol/glycerin(CAS # 56-81-5) and start FormCure with 60 ℃ / 30 mins setting. Wash off glycerol in water and dry off with paper towel.
ApplyLabWork resin printing instructions | Frequently asked questions |Demo video | ApplyLabWork support
File Info : application/pdf, 2 Pages, 104.00KB
DocumentDocumentAPPLYLABWORK PRINTING INSTRUCTIONS MSLA Spring Black (MPT-SP001BK) Check: · Resin tank and LCD screen are clean · Shake resin bottle well before use · Tank and plateform are properly fastened Printer Settings Recommendation: Brand Model Layer Bottom height Layer (mm) counts Phrozen Sonic 0.1 6 Exposure time (s) 4 Bottom Exposure (s) 30 Lifting Speed (mm/min) 60 Lifting Distance (mm) 8 Retract Speed (mm/min) 120 Sonic 0.1 6 5.5 30 60 mini Sonic 0.1 10 4 60 60 Mighty 4 K Elegoo Mars2 0.1 6 3.6 30 60 Pro Mars3 0.1 6 3.6 30 60 8 120 8 120 8 120 8 120 Layer Bottom Exposure Bottom Lifting Lifting Retract height Layer time Exposure Speed Distance Speed (mm) counts (s) (s) (mm/s) (mm) (mm/s) Anycubic MonoX 0.1 6 2.2 30 1 8 2 - Light-off Delay = 15s under current lift-retract motion. [ When printing large object, increase Lifting Distance and recalculate Light-off Delay ] - For Sonic Mighty 4K, please set Transition Layer Count to 20 *Light intensity varies each printer. Please adjust exposure time ±0.1~0.5 second and/or XY dimesion ratio according to printing result and part application. Parts Recommendation: · Avoid large aspect-ratio geometry (e.g. thin wall or long thin rod) in the sturcture to reduce failures. · If support is needed, please set contact diameter>1.2(mm), and density>60% Washing: Wipe off excess resin on printed parts with paper towel, submerge into 95% IPA and place the container in ultrasonic bath, wash for 5 minutes. Replace by clean IPA and repeat ultrasonic washing for another 5 mintes (total 10 minutes). Blow off all excess IPA and set parts in a shaded, ventilated place to dry at least 2 hours before curing. *Dried print will be tacky to touch Prototype Engineering Series APPLYLABWORK PRINTING INSTRUCTIONS Post-curing (Mandatory): Submerge the parts into glycerol/glycerin(CAS # 56-81-5) and start FormCure with 60 / 30 mins setting. Wash off glycerol in water and dry off with paper towel. * If prints don't sink completely into glycerol, add water (no more than half of volume) to adjust liquid density. ** If prints are still tacky to touch after post-curing, rinse with acetone (CAS # 67-64-1) for no more than 1 minute will significantly reduce tackiness. Storage: · Keep resin away from heat and light. · NOT accessible to children. Note: · Keep printing environment well ventilated. · Wear gloves when handling Spring resin and avoid direct contact. · Vibration of the parts during printing process might cause resin splash onto printer 's cover. Use paper towel and IPA to clean immediately. · Don't leave the parts on building platform after printing for more than one day. · Spring resin should NOT use with food, drink, or on/in the human body unless specifically indicated. Prototype Engineering Series