Feel Maestro Electric Mill MR 1615

Brand: Feel Maestro

Technical Specifications

Model: MR-1615
Rated Power: 25W
Input Power: 10W
Protective Class: Class III (against electric shock)
Protection Class: IPX0 (ingress protection)

Product Description

The electric mill consists of the following parts:

1. Charging Socket
2. Indicator Light
3. On/Off Button
4. Upper Body
5. Container
6. Container Cover
7. Light (Indicator)
8. Adjuster
9. Type-C Charging Cable

How to Charge

To charge the device:

Connect the USB Type-C charging cable to a power adapter and then to an electrical socket.
Plug the Type-C cable into the charging port located at the top of the mill, ensuring it is fully inserted.
During charging, the indicator light will illuminate to show that charging is in progress.
The indicator light will turn off once the battery is fully charged.
A full charge takes approximately 2.5 hours.

Diagram Description (pic.2): Shows the Type-C cable connecting from a power adapter plugged into a wall socket to the top port of the electric mill.

Cautions

This product is equipped with a lithium-ion rechargeable battery.
When the device is not in use, it is recommended to charge the battery every three months to ensure its service life.
Use only safety-approved charging adapters with a 5V output voltage for charging.

How to Use

To use the electric mill:

Hold the grinder firmly. Switch the container cover to the 'Open' position as indicated.
Add pepper or salt into the container.
Restore and lock the container cover.
Rotate the adjuster to set the desired coarseness of the grind.
Press and hold the ON/OFF button to start grinding. Release the button to stop.

Diagram Description (pic.3): Illustrates opening and closing the container cover and adding spices. The adjuster mechanism is shown with 'Open' and 'Close' settings.

Diagram Description (pic.4): Shows the coarseness adjustment dial, marked with 'Coarse' and 'Fine' settings.

Diagram Description (pic.5): Depicts a hand pressing the ON/OFF button on the mill, with ground spices being dispensed.

The adjustment knob can be rotated through multiple turns to achieve settings between the finest and coarsest grind.

To adjust to Fine: Rotate the adjuster from 'COARSE' towards 'FINE'. Continue rotating for a few more turns until the desired fineness is achieved.
To adjust to Coarse: Rotate the adjuster from 'FINE' towards 'COARSE'. If the adjuster becomes loose, it may be due to pepper grains stuck in the burr. Turn the device on for 1 second to dislodge any blockage, then continue adjusting. This is a normal characteristic of the ceramic burr and does not affect normal use.

Diagram Description (pic.6): An exploded view of the internal components of the mill, showing the parts of the grinding mechanism.

Important Note: When the container is filled with spices, do not hold the grinder upside down for extended periods. This can cause spice particles to enter the battery compartment and lead to battery corrosion.

Troubleshooting

If the grinder does not work or stops during grinding:

Charge the device. (Note: It is not recommended to use the product while it is charging.)
Adjust the adjuster counter-clockwise.

If the grinder continues to malfunction after performing these steps, please contact the vendor for service.

Environmental Protection and Disposal

The equipment is marked with the crossed-out garbage container symbol, in accordance with European Directive 2012/19/EC on waste electrical and electronic equipment (WEEE). This indicates that the product should not be disposed of with household waste at the end of its life.

Users are obliged to hand over the equipment to a designated collection point for electrical and electronic waste. Improper disposal can harm human health and the environment due to hazardous components. Proper handling ensures the avoidance of negative environmental and health impacts.

The manufacturer is not liable for any damage caused by intended or improper use of the equipment. The manufacturer reserves the right to change product specifications at any time without prior notice for design, commercial, aesthetic, or other reasons.