JBL Club Subwoofer Shallow Enclosures
Thank you for choosing this JBL product. This product has been designed to deliver great bass performance from a compact, easily installed enclosure. To get the best performance from your enclosure, we strongly recommend that you entrust installation to a qualified professional. Although these instructions explain how to install your enclosure in a general sense, they do not show specific installation methods that may be required for your particular vehicle. If you do not have the necessary tools or experience, do not attempt the installation yourself. Instead, please ask your authorized JBL car audio dealer about professional installation. To help us serve you better if your enclosure ever requires warranty service, please retain your original sales receipt and serial number.
Installation Warnings and Tips
Installation Tips
- Always wear protective eyewear when using tools.
- Turn off all audio components and other electrical devices before you start. Disconnect the negative (-) lead from your vehicle's battery.
- Check clearances on both sides of a planned mounting surface. Be sure that screws or wires will not puncture brake lines, fuel lines or wiring harnesses, and that wire routing will not interfere with the safe operation of the vehicle.
- When making electrical connections, make sure they are secure and properly insulated.
- Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl, to keep material from snagging in a drill bit or saw.
- Do not mount speakers where they will get wet.
Choosing a Mounting Location for the Enclosure
Choose a mounting location that doesn't interfere with cargo, the fold-down rear seat or the trunk lid. The best location is usually a corner of the trunk or cargo area. Securely mount the enclosure to the mounting surface.
WARNING: Playing loud music in an automobile can permanently damage your hearing as well as hinder your ability to hear traffic. Listening at low levels while driving is recommended. HARMAN International accepts no liability for hearing loss, bodily injury or property damage resulting from use or misuse of this product.
Speaker Connections
Connect the + and - terminals on the enclosure to the amplifier's outputs, observing proper polarity. Use at least 4mm² (11 AWG) speaker wire for the connections to the enclosure of Club 1000SSL, Club 1200SSL.
[Diagram showing connection between Battery, Head Unit, Amplifier, and Subwoofer]
Specifications
| CLUB 1000SSL | CLUB 1200SSL | |
|---|---|---|
| Subwoofer: | 10" (250mm) Aluminum Driver | 12" (300mm) Aluminum Driver |
| Power Handling: | 350W RMS, 1050W peak | 400W RMS, 1200W peak |
| Sensitivity (1W/1m): | 82.5dB | 85dB |
| Frequency Response (-6dB): | 35Hz-400Hz | 30Hz-400Hz |
| Nominal Impedance: | 2 ohms | 2 ohms |
| Voice Coil Diameter: | 2" (50mm) | 2" (50mm) |
| Enclosure dimensions: | 334mmD x 630mmW x 115mmH 13-1/8"D x 24-7/8"W x 4-1/2"H | 370mmD x 700mmW x 125mmH 14-5/8"D x 27-5/8"W x 4-7/8"H |
| Enclosure materials: | 3/4" (18mm) MDF with black carpet covering | 3/4" (18mm) MDF with black carpet covering |
General Care
The loudspeaker may be cleaned with a damp cloth. Do not use any cleaners or solvents.
A valid serial number is required for warranty coverage. This product is designed for mobile applications and is not intended for connection to the mains.
Installation Hardware
Caution: using wrong screws might cause box damage!
[Diagram showing the correct screws for installation: 4x Hexalobular Socket Head M6*25 Screws and 8x M5*15 Screws]
