Manual-Hub.com - Free English product PDF Documents!
Instruction Manual for Whirlpool models including: WDF550SAA, WDF550SAA Undercounter Dishwasher, Undercounter Dishwasher, Dishwasher, WDF550SAF
WHIRLPOOL WDF550SAF (01) PDF MANUAL - Manual-Hub.com
File Info : application/pdf, 1 Pages, 764.07KB
DocumentDocumentUndercounter Dishwasher PRODUCT MODEL NUMBERS WDF550SAAWDF550SAF Electrical Requirements:120-volt, 60-z, AC-only, 15- or 20-amp fused electrical supply. Copper wire only. A timedelay fuse or circuit breaker and separate circuit is recommended. If direct wiring dishwasher: Use flexible, armored, or nonmetallic, sheathed copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances. Use a UL Listed or CSA Approved strain relief. If connecting dishwasher with a power supply cord: Use Power Supply Cord Kit (Part Number 4317824) marked for use with dishwashers. Follow the kit instructions for installingthe power supply cord. Power supply cord must plug into a grounded 3 prong, outlet, located in the cabinet next to the dishwasher opening. Outlet must meet all localcodes and ordinances. Water Supply Requirements:A hot water line with 20 to 120 psi (138 to 862 kPa) water pressure. Watertemperature must be 120°F (49°C) water at dishwasher.U se ³/" O.D. copper tubing with compression fitting orflexible braided water supply line (Part Number 4396897RP)(¹/" minimum plastic tubing is not recommended). Use a90°elbow with ³/" hose connection with rubber washer. Donot solder within 6" (15.2 cm) of the water inlet valve. Drain Requirements: Use the new drain hose supplied with your dishwasher. NOTE: If a longer drain hose is required: Use a new drain hose with maximum length of 10 ft(3 m) that meets all current AHAM/IAPMO teststandards. Use a new drain hose that is resistant to heat anddetergent. Use a new drain hose that fits the 1" (2.5 cm) drainconnector on the dishwasher. Connect drain hose to waste tee or disposal inlet abovedrain trap in house plumbing. Connect drain hose to house plumbing 20" (50.8 cm) minimum above the floor. NOTE: It is recommended that the drain hose either belooped up and securely fastened to the underside of thecounteror be connected to an air gap. Use a drain air gap if the drain hose is connected tohouse plumbing lower than 18" (45.7 cm) above thesubfloor or floor. Drain Air Gap air gap PRODUCT DIMENSIONS Side View 24" (61 cm)* Rear View 23 5/9"(59.8cm) 32¹/" to 34¹/" (82.6 to 87.6 cm) 16 5/8"(42.2 cm) * To front of door frame 2 ¹/" (6.2 cm) CABINET CUTOUT DIMENSIONS 34" to 35" (86.4 cm to 88.9 cm) A (10.2 c4m" ) 24" (61 cm) minimum 6" (15.2 cm) 24 (61 cm) maximum A. All surfaces free from intrusions * Underside of countertop to floor NOTES: Cut holes in shaded area of cabinet walls or floor for plumbing and electrical service. ADA installation32¹/" (82.5 cm) beneath 34" (86.4 cm) high countertops may be accomplished by adjusting the toekick and leveling legs. Use ¹/" (1.3 cm) minimum I.D. drain line fittings. NOTE: Do not connect drain lines from other devices to thedishwasher drain hose. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. W10518038-D-WH 5/1/16 https://manual-hub.com/