User Manual for FALCON models including: 2BOZ9-ME650L, 2BOZ9ME650L, me650l, ME6-50L Thermal Imaging Camera, ME6-50L, Thermal Imaging Camera, Imaging Camera, Camera
HONG KONG FALCON OPTICS CO., LIMITED ME650L thermal monocular 2BOZ9-ME650L 2BOZ9ME650L me650l
Medusa Series 1 2 3 4 White Hot, High Contrast, Black Hot, Low Light, Fusion. Default: White Hot. Enable/Disable CVBS video output. Turn on the WiFi function in the device menu, then enable WiFi on your smartphone and open the dedicated app. Locate the device's WiFi MAC address (e.g., "*--**") and connect by entering the password "12345678". Once the device and smartphone are connected via WiFi, you can observe real-time images captured by the device. On/Off. Short press the menu button to freeze the image. Briefly press the REC button to move to the X and Y axis values, and use the up and down buttons to adjust the reticle position until it aligns with the impact point. Short press the REC button to move to other options. Once the settings are complete, navigate to the save option and briefly press the menu button to save and exit. Press and hold the menu button to exit without saving. The set distance will be saved as the zeroing point name in the zeroing storage menu. On/Off. Meters/Yards. 5 6 WLAN XX-XX-XXX XX-XX-XXX 7 8 9 10 11 FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.Adobe Illustrator 28.0 (Windows) GPL Ghostscript 10.04.0