Instruction Manual for Shenzhen Shi Aiker Electronic Technology models including: AP05, 2AVG2-AP05, 2AVG2AP05, AP05 Magnetic Wireless Charger Stand, Magnetic Wireless Charger Stand, Charger Stand, Stand
Shenzhen Shi Aiker Electronic Technology Co., Ltd. AP05 Magnetic Wireless Charger Stand 2AVG2-AP05 2AVG2AP05 ap05
,iPhoneiOS
1. 1
5.0V 2.0A 9.0V 2.2A 15WMax 110-205KHz 75% Ø57.8*7.7mm
82%charged
Magnetic Wireless Charger Stand
bracket
1. 2. 3. 4. 5.USB-A&C PDQC 6.15W
Product Introduction
Thanks for choosing us! This is a Magnetic Wireless Charger Stand for iphone with the latest version of iOS.Please read the manual carefully before using the product,and keep properly for checking.
2.2
Bracket Using Instructions
1. For magnetically using: Pull out the bracket to the other end of the data cable, and it can be easily used, as Figure 1;
Function Description
82%charged
bracket
Features
1.There is a ring of magnets inside the product, which can be charged on the back of mobile phone through magnetic suction function ; 2.This product has two charging methods: magnetic suction type, bracket type; 3. This is a ultra-thin, small size product and convenient to carry; 4. This product is an integrated wireless charger, not need additional cable; 5. This product input port sepcification is USB-A&C,which can be matched with PD or QC adapter at will; 6. This product supports 15W fast charging.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to thefollowing two conditions: 1) this device may not cause harmful interference, and 2)this device must accept any interference received, including interference that maycause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 15 cm surrounding the device and 20 cmabove the top surface of the device must be respected.
2. For standing using: Put the bracket pull to the back of the magnetic wireless charger, insert it into the stuck buckle position in Figure 2, and then put the charger on the desktop for vertical charging, freeing your both hands.
Input Output Frequency Efficiency Product Size
5.0V 2.0A 9.0V 2.2A 15WMax 110-205KHz 75% Ø57.8*7.7mm
Adobe Illustrator 24.0 (Windows) Adobe PDF library 15.00