Instructions for TYREDOG models including: TDA-4C, TD1000A, Tyre Pressure Monitoring System, TDA-4C TD1000A Tyre Pressure Monitoring System, TDA-4C Tyre Pressure Monitoring System, Tyre Pressure Monitoring System
TDA-4C Tyre Pressure Monitoring System – TYREDOG TPMS Australia
TYREDOG™ Manuals & Programming Instructions
TDA-4C / TD1000A LEARNING PROCEDURE
There are two ways to learn your new leanable sensors into you TDA-4C/TD1000A monitoring kit, follow the steps below to successfully install your new Sensor.
Method 1:
1) With the Monitor powered OFF - Hold down the Top Mute button on the right hand side of the monitor and continue to hold the Mute Button down while powering the monitor ON with the switch located on the right hand side of the Monitors Enclosure. DO NOT RELEASE MUTE BUTTON UNTIL "L.E.N." APPEARS/DISPLAYS ON THE MONITOR. Once "L.E.N." appears on the monitor, release Mute Button.
2) Obtain the new Learnable Sensor/Sensors and take off the cap of the sensors to allow the battery to be inserted.
3) With the Cap off and the battery out, insert the battery into the sensor and the monitor will beep and the position of the new learnable sensor will change on the display. See Fig 2. As an example where Position 3 (left Hand Rear) Press middle Button (TEMP BUTTON)to exit learn mode, Process complete. Note: If the Monitor doesn't beep, try removing or inserting the battery a few times.
Method 2:
1) Turn the monitor on and wait 3 seconds, the vehicle layout will be displayed on the monitor. Press and Hold top Mute Button for around 10 seconds ("SET UNI" WILL APPEAR BEFOR "L.E.N." CONTINUE TO HOLD BUTTON) until L.E.N. appears on the screen. Once L.E.N. appears on screen, follow steps 2 and 3 in Method:1
FIG. 1
MUTE BUTTON
FIG. 2
TEMP. BUTTON
BACKLIGHT BUTTON
SENSOR NO.3 LEARNING SUCSESSFUL
Service Adobe PDF Library 21.5.92