Instruction Manual for Remote Tech models including: JLR2, RT-KR55W, RT-KR55W Remote Key, Remote Key, Key
Remote Tech LLC JLR2 2AOKM-JLR2 2AOKMJLR2 jlr2
Unlock key Lock Light Company: Remote Tech LLC Address: 310 ALDER RD,Dover,DE 19904,USA Name: Remote Key Model: RT-KR55W Panic Trunk Operation instructions 1. 2 2 2. 1. After matching the key to the car, press the unlock key for 2 seconds to open the door and press the lock key for 2 seconds to close the door. 2. The ignition key is used to manually unlock and start the car. Product parameters Rated voltage Working current Operating voltage Transmit power Key operation force Operating temperature Stand-by current transmitting frequency Modulation Battery Key durability DC 3V <5mA 1.8V~3.6V >-20dbm 200±50g -5°C +45°C <1uA 315M±75KHZ ASK CR2032 100,000 More than 100,000 times This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement.Microsoft Word 2013 Microsoft Word 2013