Agri-Tech Solutions - Home
Instructions for WhatsGPS models including: G21L, G21L High Quality GPS Tracker, High Quality GPS Tracker, GPS Tracker, Tracker
SEEWORLD Technology Co.,ltd G21L 2AWTV-G21L 2AWTVG21L g21l
File Info : application/pdf, 5 Pages, 3.61MB
DocumentDocumentLED type LED status Flash Slow flash Green Always on Meaning Network initializing The network reception signal is normal Network/GPRS online Not bright Network signal is not received /the card is not inserted Flash BD/GPS signal search Blue Always on BD/GPS positioning success Not bright GPS sleeping/not working Red Always on Connect the external power Not bright Disconnect external power 2.4 Relay Wiring Instructions Remote Cut-Off (Fuel /Power) wiring diagram Oil pump Green Green 87A 30 relay (12V) 86 85 USPE 2A Red Black - 9-90V 5V out DO3 DIN3 DO2 DIN2 Yellow ON Power supply ACC Orange LOCK White START Car key Relay wiring of the pump: The oil joint at both ends is a thin white line (85) and a thin yellow line (86). The thin white line (85) is connected to the positive power supply (+ 12V) of the vehicle. The thin yellow wire is connected to the device relay control wire. Cut off the positive connection cable of the pump: then connect in series to the normally closed contact of the relay (thick green line 87A), and connect the other end to the COM contact of the relay (thick green cable 30). 2.5 Installation method The installation mode of the device is hidden installation. It is recommended that the installation be carried out under the guidance of the professional and technical personnel designated by the dealer. Pay attention to the following matters: * To avoid damage by thieves, the device location should be hidden as far as possible; * Avoid being placed with transmitting sources such as reversing radars, burglars, and other in-vehicle communication devices; * Can be fixed with cable ties, or with wide sponge strong double-sided adhesive; * The device has a built-in GSM antenna and GPS antenna. When installing, it should be sure to face up (towards the sky), and there is no metal shielding above. 3. Installation Diagram Around thedashboard Under decorativepanel Under the rear windshield 4. Specification Project Operating voltage Working current Static current Target method Positioning error Communications network Specification DC 9V - 90V 53mA 11 mA GPS+BDS < 10M 2G/4G Remark 12V When not charging Communication frequency band LA: LTE-FDD B2/B4/B5/B7/B66 GSM 850/1900 MHz Communication mode TCP Range of working temperature Working humidity -20~+75 2. M10 a%RiHnjF8u5n%RcHtion Specifications size L98.5*W38*H17mm Weight 71g Built-in battery capacity 300mAh Warranty period 1 year 5. Description of Common Commands The following commands can be sent via SIM card SMS or issued via whatsgps platform 5.1 Common setup commands SN Command function Command format Remark SERVER,1,[Doma inName/IP],[po 1 Set online rt]0# Set the device to point SERVER,1,gps.wh to Server IP and port atsgps.com,68 010# APN, [APN's 2 Set APN name]#APN, cmiot# The APN varies according to the local telecom operator 3 Set upload interval TIMER,[T1]# TIMER,10# T1: 5-18000 seconds, motion upload interval, the device defaults to 10s 4 Heartbeat interval setting HBT,[T]# HBT,3# T: 1-1440 minutes, heartbeat packet upload time interval, the default is 3min 5 Set time zone GMT,[A],[b], [C]#GMT,E,0,0 # A=E/W, for the eastern and western time zones; B: 0-12, is time zone C: 0,15,30,45, which represents the half time zone and defaults to 0.