Renogy Eclipse Solar Suitcase 100W | 200W w/o CC Manual
Version 1.1
Manufacturer: Renogy
Address: 2775 E. Philadelphia St., Ontario, CA 91761
Phone: 1-800-330-8678
⚠️ Important Safety Instructions
Please save these instructions.
This manual contains important safety, installation, and operating instructions for the charge controller. The following symbols are used throughout the manual to indicate potentially dangerous conditions or important safety information.
⚠️ WARNING: Indicates a potentially dangerous condition. Use extreme caution when performing this task.
⚠️ CAUTION: Indicates a critical procedure for safe and proper operation of the controller.
ℹ️ NOTE: Indicates a procedure or function that is important to the safe and proper operation of the controller.
General Safety Information
- Read all of the instructions and cautions in the manual before beginning the installation.
- It is HIGHLY recommended to install a charge controller in order to charge your batteries using the solar suitcase.
- It is dangerous for unregulated panels to be connected to battery banks.
Battery Safety
- Use only sealed lead-acid, flooded, or gel batteries which must be deep cycle.
- Explosive battery gases may be present while charging. Be certain there is enough ventilation to release the gases.
- Be careful when working with large lead acid batteries. Wear eye protection and have fresh water available in case there is contact with the battery acid.
- Carefully read battery manuals before operation.
- Do NOT let the positive (+) and negative (-) terminals of the battery touch each other.
- Recycle battery when it is replaced.
- Over-charging and excessive gas precipitation may damage the battery plates and activate material shedding on them. Too high of an equalizing charge or too long of one may cause damage. Please carefully review the specific requirements of the battery used in the system.
- Equalization is carried out only for non-sealed / vented/ flooded / wet cell lead acid batteries.
- Do NOT equalize sealed / VRLA type AGM / Gel cell batteries UNLESS permitted by battery manufacturer.
General Information
The Renogy Eclipse Solar Suitcase is specifically designed for mobile off-grid applications, where space and weight limitations are abundant. The Solar Suitcase models support 12V deep cycle battery varieties such as sealed-lead acid, gel, and flooded. With built-in tilting stands, these panels can be adjusted at different angles to maximize the power output throughout the seasons.
The alligator clips included in this package make it easy to connect the panel to a battery in seconds. If one ever needs to connect a battery with a different type of end terminal, the alligator clips are attached via MC4 Connectors.
Key Features
- Tilting stand for maximum solar generating potential.
- Convenient storage case for easy transportation.
- High efficient monocrystalline solar panels
ℹ️ NOTE: The suitcase requires an adaptor kit, a charge controller, and a tray cable. These components require a separate purchase.
Identification of Parts
Diagram showing the back of the Renogy Eclipse Solar Suitcase. Key parts are labeled with numbers:
- 1. Junction Box
- 2. Tilt Stands
- 3. Latches
- 4. Handle
- 5. MC4 Connections
Installation
Step 1: Unlatch and unfold
Diagram illustrating the first step of installation: Unlatching and unfolding the solar suitcase. An arrow indicates the unfolding motion. Two checkmarks [checkmark emoji] indicate completion of the step.
Step 2: Adjust Tilt Angle
Diagrams illustrating the second step of installation: Adjusting the tilt angle. This involves unscrewing a butterfly nut, tilting the panel to the desired angle, and locking the nut. Arrows show the adjustment motion. A checkmark [checkmark emoji] indicates successful adjustment.
Diagram showing the solar suitcase tilted at an angle, with a label 'θ' indicating the tilt angle. Text provides recommended angles for different seasons:
- Summer: θ = Latitude - 15°
- Fall and Spring: θ = at latitude
- Winter: θ = Latitude + 15°
To maximize the output, adjust the angle of the suitcase regularly to track the sun's movement throughout the season.
Recommended Wiring
The Solar Suitcase is shipped by itself without any additional components. In order to utilize the suitcase efficiently, it is highly recommended that users put their system together with the following components:
- Adapter kit: Has an MC4 connection on one end and bare wire on the other end for connecting to a charge controller.
- Charge controller: Regulates the solar panel power to efficiently charge batteries.
- Tray cable: Has a bare wire on one end and a battery “O-ring” on the other end for connecting the charge controller to the battery bank.
- Battery bank: Where power from the solar panels will be stored.
ℹ️ NOTE: Depending on the user's preference, different gauge wires, wire lengths, charge controllers, and cables could possibly be used.
Step 1: Use tray cable to connect battery bank to charge controller's battery terminals
Diagram illustrating the use of a tray cable to connect a battery bank to a charge controller's battery terminals. Two diagrams show the charge controller with connections.
Step 2: Connect adapter kit to MC4 connections coming from the suitcase's junction box
Diagram illustrating the connection of the adapter kit to the MC4 connectors on the solar suitcase's junction box. The diagram shows the back of the suitcase with MC4 connectors and the adapter kit with MC4 plugs.
Step 3: Connect adapter kit to charge controller PV terminals
Diagram illustrating the connection of the adapter kit to the charge controller's PV terminals. Two diagrams show the charge controller with connections.
Frequently Asked Questions
Q. Can the kit charge two or more 12V batteries connected in parallel?
A. Yes, it's possible if the batteries have the same type and capacity and are wired in parallel as a single 12V battery bank.
Q. Is there any risk that the solar kit will over charge my battery?
A. One of the functions of the solar charge controller is to ensure that your battery is not over charged; therefore there is no risk of overcharge.
Q. Can I extend the battery leads?
A. Yes, it's possible – please choose the same size of cable for extension. However, the longer the extension, the greater the line loss. Bigger gauge will be required for longer runs.
Q. Do I need to clean the solar panels?
A. Yes, it is recommended for better performance. Dust and dirt should first be swept off the panel surface using a soft brush. When the sweeping is complete, use a wet cloth to wipe the panel surface to remove remaining dirt and grime.
Q. Can rain damage the solar kit?
A. The solar panels are fully waterproof (IP66 class), the controller is not. We recommend protecting the kit from rain, since water into controller may damage the internal circuitry.
Technical Specifications
Solar Panel Parameters
| Description | 100 W Parameters | 200 W Parameters |
|---|---|---|
| Maximum Power | 100 W | 200 W |
| Open Circuit Voltage (Voc) | 21.6 V | 21.2 V |
| Short Circuit Current (Isc) | 6.10 A | 11.72 A |
| Maximum Power Voltage (Vmp) | 17.6 V | 17.7 V |
| Maximum Power Current (Imp) | 5.68 A | 10.35 A |
| Cell Type | Monocrystalline | Monocrystalline |
| Operating Temperature | -40°F to +185°F | -40°F to +185°F |
| Folded Size | 21.1 X 21.5 X 3.1 in | 41.3 X 21.1 X 3.1 in |
| Net Weight | 19.40 lbs. | 33.60 lbs. |
Dimensions
100W Eclipse Suitcase
Diagram showing the dimensions of the 100W Eclipse Solar Suitcase. It includes a side profile view and a top view with measurements: overall width 45.46 inches, panel width 43.01 inches, depth 21.47 inches, height 21.25 inches, thickness 1.57 inches. A bullet point lists leg stand length: 18 inches (long part), 14.5 inches (short part).
200W Eclipse Suitcase
Diagram showing the dimensions of the 200W Eclipse Solar Suitcase. It includes a side profile view and a top view with measurements: overall width 45.68 inches, panel width 42.63 inches, depth 21.28 inches, height 40.97 inches, thickness 1.57 inches. A bullet point lists leg stand length: 26.3 inches (long part), 23.3 inches (short part).
