Scarlett SC-SI30K59 Steam Iron

Product Overview

The Scarlett SC-SI30K59 is a steam iron designed for home use, featuring a professional metal-ceramic coating (KeramoPro) for enhanced durability, glide, and 100% resistance to burning.

Important Safeguards

• Please read the instruction manual before use and save it for future references.
• Before the first switching on, check that the voltage indicated on the rating label corresponds to the mains voltage in your home.
• For home use only. Do not use for industrial purposes. Use the steam iron only for its intended use.
• Do not use outdoors or in damp areas.
• Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.
• Do not allow the cord to touch sharp edges and hot surfaces.
• Always unplug the steam iron from the power supply when filling with water or emptying and when not in use.
• To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If this happens, DO NOT TOUCH the appliance, unplug it immediately, and check in a service center.
• In case of power cord damage, its replacement should be done by the manufacturer, service department, or another highly skilled person to avoid any danger.
• The appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or persons with lack of life experience or knowledge, unless they are under supervision or have been instructed about the use of the unit by a responsible person.
• This appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Cleaning and user maintenance shall not be made by children without supervision.
• Children must be under control to prevent them from playing with the appliance.
• Keep the iron and its cord out of reach of children less than 8 years of age when it is energized or cooling down.
• Do not attempt to repair, adjust, or replace any parts of the appliance. Check and repair malfunctioning appliances only at the nearest service center.
• Do not leave the iron unattended while hot or connected, or on an ironing board.
• If ironing is interrupted, stand the iron on its heel rest only; do not place the steam iron on metal or rough surfaces.
• Iron should be used and stored on a flat, stable surface.
• Iron should not be used if it is dropped, if there are visible signs of damage, or if it leaks.
• CAUTION: To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
• If the product has been exposed to temperatures below 0°C for some time, it should be kept at room temperature for at least 2 hours before turning it on.
• The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless such changes significantly influence the product safety, performance, and functions.
• Manufacturing date is indicated on the unit and/or on packing, as well as in accompanying documents, in the format XX.XXXX, where the first two figures XX represent the month of production, and the following four figures XXXX represent the year of production.

How to Use

Setting Temperature

Always check whether a label with ironing instructions is attached to the article to be ironed. Follow these instructions in all cases.

Turn the temperature control dial to set the appropriate temperature indicated in ironing instructions or on the fabric label.

Insert the mains plug into the wall socket. The indicator light will turn on.

When the indicator light goes out, you may start ironing.

Water Tank Filling

• Unplug the iron before filling the water tank.
• Hold the steam iron in a horizontal position.
• Slowly pour water through the water inlet.
• Do not fill higher than the mark on the water tank to avoid water spilling.
• The opening used for pouring water should be closed when the iron is in use.
• Always unplug the iron from the power socket when refilling the water reservoir.
• NOTE: Your steam iron is designed to use tap water. However, if the water is very hard, it is advisable to use distilled water.
• NOTE: Do not use chemically de-limed or perfumed water.
• NOTE: If you have very hard water, it is advisable to use only distilled or demineralized water.
• The water tank should be emptied after each use.

Spraying

As long as there is enough water in the water tank, you may use the spray button at any temperature setting during steam or dry ironing.

Press the spray button several times to activate the pump while you are ironing.

Steam Ironing

• With the unit unplugged, fill the steam iron with water.
• Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug it in.
• Set the temperature control dial to the ".." or "..." position.
• Set the variable steam control to the desired position.
• When finished, turn the temperature dial counterclockwise to the minimum position and unplug the appliance from the power supply.
• CAUTION: Avoid coming in contact with ejected steam.

Dry Ironing

The steam iron can be used on the dry setting with or without water in the water tank; however, it is best to avoid having the water tank full while dry ironing.

Turn the variable steam control to the minimum position (0).

CAUTION: If the steam iron has been used for a long time, it is hot, and there is no water, do not refill it with water until the steam iron cools down.

Burst of Steam

The burst of steam feature provides additional steam for removing stubborn wrinkles.

Press the powerful steam button to release the burst of steam.

NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button pressed for more than 5 seconds.

NOTE: For the best steam quality, do not use more than three successive bursts each time, because the iron will cool.

Vertical Steam

• Ensure that there is enough water in the water tank.
• Stand the steam iron on its heel rest on an iron-safe surface and plug it in.
• Set the temperature control dial and variable steam control to their maximum positions.
• Hold the iron vertically and press the steam burst button; an intense steam will be ejected from the soleplate.

Anti-Drop Function

The 'Anti-drop' function prevents water spills and helps avoid blotches on the fabric which may appear when the iron works at low temperatures.

When You Finished Ironing

• Set the temperature dial to the minimum position.
• Remove the mains plug from the wall socket.

Care and Cleaning

• Before cleaning the steam iron, ensure it is unplugged from the power supply and has completely cooled down.
• Do not use abrasive cleaners.

Self-Cleaning

• Fill the water reservoir up to the maximum level and then close it.
• Set the temperature control to its maximum position.
• Insert the main plug into the wall socket.
• Holding the iron horizontally over the sink, then change the steam control to the maximum position and press the self-cleaning button.
• Boiling water and steam will be ejected from the soleplate holes, washing out impurities. Rock the iron forwards and backwards during this operation.
• Repeat self-cleaning if you notice that much impurity has been washed out.
• Move the iron over an old (preferably) piece of cloth to ensure the soleplate will be dry during storage.

Storage

• Unplug the appliance from the power supply, empty the water tank (do this after each use), and allow the steam iron to cool down completely.
• Wrap the cord around the heel rest.
• To protect the soleplate, place the steam iron in an upright position on its heel rest.

Parts Description

The following parts are identified in the manual:

• 1. Spray nozzle
• 2. Water filling inlet
• 3. Steam Blow Button
• 4. Spray button
• 5. Variable steam control
• 6. Handle
• 7. Swiveling cord protector
• 8. Heel rest
• 9. Indicator light
• 10. Half-transparent water tank
• 11. Temperature control dial
• 12. Self-cleaning button
• 13. Soleplate "KeramoPro"
• 14. Beaker

Disposal Information

The symbol on the unit, packing materials, and/or documentation means that used electrical and electronic units should not be disposed of with ordinary household garbage. These units should be taken to a special receiving point.

For additional information about actual garbage collection systems, address your local authority.

Proper utilization will help to save valuable resources and avoid negative impacts on public health and the environment that may occur from incorrect garbage handling.