Menuett Oil & Vinegar Sprayer

Safety Instructions

• Never spray over a naked flame.
• Do not place the product near a cooker or other sources of heat, as this can damage the plastic.
• The product is only intended for household use.

Operation

Use

• Remove the pump unit for cleaning.
• Grip the dosing scale, twist anticlockwise, and lift off.
• Clean all parts according to the instructions.
• Hook the two chambers together. Fill the chamber marked OIL with oil and the chamber marked VINEGAR with vinegar. Use the supplied funnel if necessary. Each chamber holds 150 ml. Never use oil or vinegar containing spices, as this can block the spray function.
• Fit the pump unit. Place the tube with the white pump filter into the oil chamber and the tube with the black pump filter into the vinegar chamber. Twist the pump unit to lock it in place.
• Adjust the dosing as shown below and press the trigger repeatedly to pump oil and/or vinegar.
• The dispersion depends on how quickly you press the trigger. Press quickly for a wide, fine dispersion. Press slowly for a more concentrated jet.

Diagram of Sprayer Components

The oil and vinegar sprayer consists of a pump mechanism and two connected chambers.

• 1. For vinegar
• 2. Trigger
• 3. For vinegar
• 4. Vinegar chamber
• 5. For oil
• 6. Spray nozzle
• 7. For oil
• 8. Transparent chamber (connector)
• 9. Oil chamber

Dosing

Equal amounts of oil and vinegar are dispensed when the arrow on the dosing scale points to 50/50. When the arrow points to 100% on the oil chamber, only oil is dispensed. When the arrow points to 100% on the vinegar chamber, only vinegar is dispensed. Turn the pump head to the desired position between 100% oil and 100% vinegar.

Thin oil at room temperature provides the best results. Thicker and/or cold oil may not be finely dispersed properly.

Tips

• Spray oil in a frying pan or baking tin for low-fat cooking.
• Spray onto salad or pasta.
• Spray grill racks and similar items. NEVER spray over an open flame.
• Store at normal room temperature, protected from direct sunlight.

Maintenance

• Remove the pump unit and carefully separate the chambers. Wash the chambers with warm water and dish soap.
• Fill the chambers to 1/3 with warm water and a little dish soap. Hook the chambers together, fit the pump unit, and pump repeatedly until all liquid is dispensed.
• Fill the chambers with clean, warm water and pump it out to rinse the dish soap from the pump system.
• NOTE: No parts of the product can be washed in a dishwasher.

Environmental Care

Recycle discarded product in accordance with local regulations.

Jula reserves the right to make changes. For the latest version of the operating instructions, see www.jula.com.