Shenzhen SED Initta Technology Co., Ltd. Z875 Point of Sale System Installation

Docking Station Installation

Continue the installation process for the docking station:

• Organize the TYPE-C cables and fasten the I/O interface cover on the main screen and the wire cover on the pillar respectively.
• Flip the main device 90 degrees. Correctly install the docking station into the base. Organize the TYPE-C cable and place it in the designated cable position. After placing the main device properly, the installation of the docking station is completed. (See Figure 5 for visual guidance).

Installing Standard Peripherals (MSR/Fingerprint Recognition/iBUTTON)

If available, install standard peripherals following these steps:

1. Plan the position for the external device (on the left or right side of the main screen). Remove the corresponding external device cover and wiring connector. Exercise caution to avoid breakage when removing.
2. Remove the external device to be installed. Locate the connection cable interface and correctly plug it into the connection cable on the main screen. Place the assembled connecting wire into the peripheral position area, paying attention to adjusting the position to prevent the wire harness from being tightly compressed.
3. After ensuring the wiring harness is adjusted correctly, assemble the peripherals onto the main screen and lock the screws separately. (See Figure 6 for visual guidance).

Connecting Peripherals, Power, and Network Directly (Without Docking Station)

When not using a docking station, connect peripherals, power, and network directly to the main screen's I/O ports:

1. Adjust the main device screen to the appropriate position. Open the I/O interface cover on the main screen and the wiring cover on the column separately.
2. Thread the connecting wires of each external device from the bottom of the device base into the column from bottom to top.
3. Connect these wires correctly to the I/O ports of the main screen.
4. Simultaneously connect the power supply and network cables. Ensure all connections are correct and stable.
5. Adjust the length and position of the wiring harness for each peripheral device.
6. Fasten the I/O interface cover and wire cover respectively. (See Figure 7 for visual guidance).