Instruction Manual for GE current models including: IND625, Emergency Exit Sign, IND625 Emergency Exit Sign
INSTALLATION INSTRUCTIONS FOR EMERGENCY EXIT SIGN
IMPORTANT:
When re-lamping, only use lamps specified in the exit sign. Using other lamp types may result in transformer damage or unsafe conditions. Battery in this unit may not be fully charged. After electricity is hooked up to unit, let the battery charge for at least 24 hours. Normal operation of this unit should then take effect (when applicable).
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
'R QRW XVH RXWGRRrs. 'R QRW PRXQW QHDU gas or electric heaters. (TXLSPHQW VKRXOG EH PRXQWHG LQ ORFDWLRQV DQG DW KHLJKWV where it will not be subject to
tampering by unauthorized personnel. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. 'R QRW XVH WKLV HTXLSPHQW for other than its intended use. %Hfore wiring to power supply, turn off electricity at fuse or circuit breaker. &RQVXOW ORFDO building code for approved wiring and installation. ,QVWDOODWLRQ DQG VHrvicing should be performed by qualified personnel.
SAVE THESE INSTRUCTIONS!
Ceiling and End Mount Installation:
&RQQHFW LQSXW DV VKRZQ LQ ZLULQJ GLagram below and fasten canopy to the J-Box bracket.
2. Snap housing to canopy.
WIRING DIAGRAMS:
&RQQHFW WKH EDWWHry (when applicabOH WR WKH 3& %RDrd. 4. Secure faceplate to housing and remove the proper arrow as required.
AC ONLY
POWER SUPPLY PC BOARD
&HLOLQJ 0RXQW (QG 0RXQW
BATTERY BACKUP
BAT
POWER SUPPLY PC BOARD
NOTE:&RQQHFW WR D VLQJOH VRXrce of power supply so that all lamps are simultaneously illuminated.
NOTE: Properly insulate the unused lead with a wire nut or other approved means. WARNING: Unused wires must be capped using enclosed wire nuts.
Page 1 of 2
INSTALLATION INSTRUCTIONS FOR EMERGENCY EXIT SIGN
OPERATION (Battery Backup):
1. Apply A& SRZHU WR WKH XQLW TKH /(' ,QGLFDWRU VKRXOG WXrQ 5('. 2. After the battery has been left to charge for 24 hours, test the unit by pushing
the switch. TKH /(' LQGLFDWRU WXrQV 2)) DQG WKH /(' ERDrd sta\V 21 3. When the switch is rHOHDVHG WKH /('V WXrQ 2)) DQG WKH /(' LQGLFDWRU WXrns
bacN WR 5('.
MAINTENANCE:
&DXWLRQ $Oways turn off A& SRZHU WR WKH HTXLSPHQW EHfore servicing. Servicing should be performed only by a qualified service technician. Use onl\ 0$18)A&785(5 VXSSOLHG replacement parts.
BATTERY: The battery supplied with the Battery Backup model requires no maintenance. However, it should be tested periodicall\ VHH 7(67,1* DQG replaced when it no longer operates the connected fixtures for the duration of a 30-second or 90-minute test. The battery supplied in this equipment has a life expectancy of 5 years when used in a normal ambient temperature of 72º).
TESTING:
1DWLRQDO (OHFWULF &RGH 1(& DQG 1)PA life safety code regulations require that routine tests need to be performed as listed below: 2QFH every month, the unit needs to be tested for duration of 30 seconds. Push in and hold the test switch to perform. this test 2QFH every 12 months, a full 90 minute (per UL requirements) test needs to be perforPHG RQ WKH XQLW 'LVFRQQHFW SRZHU WR WKH unit and leave it in the emergency mode. TKH /('V VKRXOG VWa\ 21 for at least 90 minutes.
Page 2 of 2
Acrobat Distiller 8.0.0 (Windows)