JVC Quick Start Guide
Getting Started
This guide provides essential steps to set up your JVC television.
Step 1: Insert Batteries into Remote Control
Insert two AAA/R3 or equivalent batteries into the remote control. Ensure correct polarity (+/-) and replace the battery cover.
[Image: Remote control battery compartment with batteries inserted]
Step 2: Connect Antenna to TV
Connect the antenna to the appropriate port on the rear of the TV. Note that connection options may vary by model.
[Image: Rear side of a TV showing LNB and ANT connection ports]
Step 3: Connect TV to Mains Socket
Connect the TV's power cord to a mains electrical socket.
[Image: Wall socket with a TV power plug being inserted]
Step 4: Switch TV On
After connecting the power cord, the standby LED will illuminate.
To switch on the TV from standby mode, you can:
- Press the Standby button, a numeric button, or the Programme +/- button on the remote control.
- Alternatively, use the TV's side control buttons:
- Press the middle of the side function switch (2a).
- Press the control button (2b).
- Press the control button (2c).
- Press the center of the joystick or push it up/down (2d).
Note: The appearance and location of remote control buttons and TV control buttons may differ depending on the model.
[Image: Diagram showing various methods to turn on the TV using the remote and TV's side controls]