Comfort Zone CZ488 Series Oscillating Ceramic Heater
Product Overview
A tall, cylindrical oscillating ceramic heater with a black finish. It features a perforated grille on the front and sides for heat distribution, a control panel located near the base with distinct settings like OFF, FAN, LOW, and HIGH, and an ON/OFF Power Level Control dial. A Power Indicator Light is visible. The heater sits on a rounded base. The brand "Comfort Zone" and model series "CZ488 Series" are prominently displayed.
Features:
- 80° Oscillation
- Three Settings:
- High - 1500 watts (5120 BTU)
- Low - 800 watts
- Fan Only
- Fan Forced Air Circulation
- Front Mounted Control Panel
- Power-On Indicator Light
- Safety Overheat Protection
- Safety Tip-Over Switch
- Convenient Carry Handle
- 120V A.C., 60Hz, 12.5A
Website: www.comfortzoneproducts.com
Safety Instructions & Intended Use
Intended Use
This product is intended for indoor residential and office use only, not for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. This heater must be plugged into a 120 Volt A.C., 15 AMP (or larger) circuit. Do not plug anything additional into the same circuit. If you have any questions whether your wiring is adequate, consult a qualified electrician. Risk of fire, overheating, malfunction, property damage, injury or even death may result if not adhered to.
Use your heater only with a working smoke detector located in the vicinity of your heater.
While using your heater, you should follow the IMPORTANT INSTRUCTIONS listed below. As part of those instructions, we have used the word "WARNING" to indicate the level of hazard: WARNING indicates a hazard which, if not avoided, could result in injury or death.
Important Instructions
- Read all the instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use provided handle when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 meters) from the front of the heater and keep them away from the sides and rear.
- Do not use heater unattended. Use of extreme caution is necessary when any heater is used by or near children, invalids, disabled persons or pets.
- Do not operate the heater with a damaged power cord or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment or repair.
- Do not use heater outdoors.
- Use your heater only in dry environments. This heater is not intended for use in a bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate heater where it may fall into a bathtub or other water container. Do not use in damp environments such as flooded basements.
- Do not place the heater on a small, unlevel, uneven or any surface which might allow heater to tip or fall.
- For proper operation, heater should be placed on a smooth, non-combustible surface. Do not place on rugs, carpet, vinyl flooring or other plastic surfaces. Not for use outdoors or in wet areas.
- This heater is not designed as a primary heat source.
- Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip). Always unplug heater when not in use.
- Do not run power cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings. Arrange cord away from traffic area where it will not be tripped over.
- To disconnect heater, turn controls off then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons or property.
Warnings
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is not intended for use in a bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate heater where it may fall into a bathtub or other water container. Do not use heater outdoors. Do not use in damp environments such as flooded basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot when in use, to avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use near combustible materials or flammable gases or sources of heat. Do not use in areas where gasoline, paint or flammable materials are used or stored. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 meters) from the front of the heater and keep them away from the sides and rear. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the heater.
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate electrical system that is up to code. The supply cord has a polarized plug. As a safety feature this plug will fit in a polarized outlet only one way. To prevent electric shock, match wide blade of plug to wide slot, fully insert plug. If the plug does not fit contact a qualified electrician. Do not operate any heater with a damaged cord or plug or after heater malfunctions, has been dropped or damaged in any manner. Do not operate heater with a broken heating element or ceramic cone or any visual imperfections. For repairs covered under warranty, see warranty statement. For all other repairs contact Comfort Zone® Customer Service by telephone or mail for information and assistance.
Pet Owners Note
The health of birds and some small pets are extremely sensitive to the fumes given off during the initial use of many appliances. Although these fumes are not harmful to humans, it is recommended that this heater not be used around birds and small pets during its initial use until the manufacturing corrosion coatings burn off.
Usage
Heater Operation
Always operate the heater in the upright position following all instructions and recommendations listed in this manual.
Heater Location
Place the heater in the area of the room that is coldest. The heater should not be placed immediately under a power outlet.
Heater Connection
Plug heater directly into 120 Volt A.C., 60Hz wall outlet. Be sure plug fits tightly in outlet. A loose connection may cause overheating and damage to the plug or heater.
Note: To prevent overloading a circuit, do not plug the heater into a circuit that is servicing other electrical needs.
Turning Heater On
To start the heater, turn the ON/OFF Power Level Control from the «OFF» position to the «FAN», «LOW» or «HIGH» setting. During the heater's initial use, you may experience a slight odor or smoking. This is the result of the heating element lubrication "burning off". This is normal and will go away after a few minutes of use.
[Diagram: Control Panel showing Power Indicator Light, Oscillation Control (OSC), and ON/OFF Power Level Control dial with OFF, FAN, LOW, HIGH settings]
Power Level Switch
This heater has two heat settings: «HIGH» and «LOW». Use the higher setting (1500 watt) to raise the room temperature quickly. When the desired temperature is reached, use the «LOW» setting. It is usually sufficient to maintain a comfortable temperature.
To Operate Fan Only
Turn the ON/OFF Power Level Control dial to the «FAN» setting.
Power Indicator Light
The Power Indicator Light will illuminate when the heater or fan is turned on.
Oscillation Control
Control the Oscillation feature on the Heater/Fan by pressing the Oscillation Control «OSC» switch located on the control panel of the heater.
Turning Heater Off
Turn the dial to «OFF» position before unplugging or plugging in the heater. Heater should be unplugged when not in use.
Care and Maintenance
Cleaning
Caution: Before cleaning the heater, be sure to disconnect power cord and allow the heater to cool completely.
Clean the outside surface with a clean damp cloth. DO NOT IMMERSE THE HEATER IN WATER. Allow heater to dry completely before use.
Do not use harsh chemicals (gasoline, benzene, paint thinner, harsh cleaners, etc.) or abrasive cleaners as they will damage the heater. NEVER USE ALCOHOL OR SOLVENTS.
Washable Filter
The heater comes with a washable filter located at the air inlet. When the filter looks dirty, simply unscrew the rear grille cover and snap it out. Remove the filter from the heater and rinse it out with warm water. BE SURE TO ALLOW THE FILTER TO DRY COMPLETELY BEFORE CAREFULLY PLACING IT BACK ON THE HEATER. Re-install safety grille cover with screws. Do not operate this heater with safety grille removed.
[Diagram: Rear view of heater showing access to washable filter via rear grille cover and screws.]
Repair
DO NOT OPERATE THE HEATER WITHOUT THE GRILLE IN PLACE. DO NOT TAKE THE HEATER APART; THERE ARE NO SERVICEABLE PARTS INSIDE. DO NOT USE THE HEATER IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
Storage
Keep original carton for storage of the heater. Coil and tie the power cord to avoid damage during storage.
Limited Warranty
This unit is guaranteed to the original retail purchaser against defects in quality or workmanship for a period of one year from the date of original purchase. If this unit fails because of a manufacturing defect within 30 days of purchase, return the unit, with your receipt, to the retailer. After 30 days, but within the warranty period, if the unit was purchased within the continental United States, return it, freight prepaid, to World and Main for repair or replacement. If the unit was purchased outside the continental United States, return the unit to the place of purchase. This warranty does not cover damage caused by misuse, abuse, overheating or alteration. Repairs made by anyone other than World and Main are not covered in this warranty. World and Main will not be held liable for any losses due to neglectful operation. All implied warranties, including the warranties of merchantability and of fitness of purpose, if applicable, are hereby limited in duration to the period of one year from the date of original retail purchase. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Incidental or consequential damages arising from a breach of either express or implied warranties are hereby disclaimed and excluded. Some states do not allow the exclusion of limitation of incidental or consequential damages, so this limitation or exclusion may not apply to you. Upon the expiration of this warranty all such liability will terminate. No other warranties are expressed or implied.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. No informal dispute settlement mechanisms are available. This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 02/15/22







