TECHKO Safe Pool S189A/S189D Area Entry Alarm
Introduction
Congratulations on your purchase of the TECHKO Safe Pool model S189A/S189D safety alarm. The Safe Pool can be used to provide a high volume alarm alert when children have entered a pool or spa area. The S189A/S189D can be used outdoors on wood doors, windows, or gates.
Features
- Easy installation for gate or door protection
- Weather / Water resistant
- (3) 1.5V AAA batteries (included)
- High output 100-110 dB 6-tone alarm siren
- One button BYPASS operation
- Low battery LED display
- Optional additional BYPASS button for delayed entry from either side of door or fence (S189A not included)
- Optional additional magnetic sensor for screen door exit / entry (S189A not included)
Important Safety Tips
- Alarm siren is very loud; NEVER place the unit close to ears.
- Install the unit high enough to be out of reach of children.
- S189D Specifics: An additional delay button may be mounted on the other side of the entrance. When pressed, it will delay the alarm 8-12 seconds before the alarm is triggered, allowing time to secure the door/gate.
- S189D Specifics: An additional magnetic sensor allows the unit to be used on sliding doors with screens. The alarm will sound only when both magnetic sensors are apart.
- Keep this manual for future reference.
The Safe Pool can provide valuable protection when used correctly. However, it cannot guarantee complete protection against accidents or injuries. TECHKO cannot be held responsible for any loss, damage, or injury that may occur.
Installation
WARNING: Read all installation and operation instructions thoroughly before proceeding. Before installing the battery, use a rubber band to temporarily secure the two magnetic sensors together with the arrows pointing toward each other to avoid setting off the alarm unintentionally during installation.
Installing the Battery
Remove the battery cover of the unit and install the new (3) 1.5V AAA batteries (included). The unit is now ON and working once the battery is connected.
Diagram Description (Fig. 1): Shows the battery compartment of the unit with space for three AAA batteries.
Testing the Alarm
If you are sensitive to loud sound, please wear ear protection against the loud alarm siren before testing. After ear protection is in place, separate the magnetic sensors apart by more than 1 inch. The alarm should sound immediately after the sensors are separated. Press the BYPASS button and immediately secure the two magnet sensors together again to avoid the alarm sounding off unintentionally.
Mounting
WARNING: The alarm should be positioned close to the door and high enough to be out of the reach of children. As each mounting application varies, TECHKO suggests testing the unit's installation location and effectiveness before permanently mounting the S189A/S189D.
Mounting Indoors Using Double-Sided Tape
Ensure that the mounting surfaces for the double-sided tapes are completely clean. Attach the double-sided tapes onto the rear of the unit, and then secure the unit onto the desired mounting surface.
Mounting Indoors Using Screw
Using the provided mounting template, mark the position of the screw hole on the desired mounting surface. Drill a screw into the mounting surface, leaving approximately 0.125 inch of thread remaining. Slide the unit over the screw and secure it by pushing it downward. The screw may need to be adjusted towards or away from the mounting surface for a more secure fit.
Diagram Description (Fig. 3): Illustrates how the unit is mounted by sliding it onto a screw or attaching it with double-sided tape.
Mounting the Sensors Indoors
Ensure that the arrows of each sensor are pointed towards each other. Using either the double-sided tape or the screw provided, mount the sensors so they are less than 1 inch away from each other. The wired portion of the magnetic sensor should be mounted on the non-moving portion of the mounting surface, and the standalone sensor on the door/gate.
Diagram Description (Fig. 4/Fig. 5): Shows sensor placement on a door/gate and wall, with arrows pointing towards each other and a maximum distance indicator of 1 inch. Also depicts application on sliding screen and glass doors.
Mounting Outdoors on Wooden Gates
Using the provided mounting template, mark the position of the screw hole on the desired mounting surface. Drill a screw into the mounting surface, leaving approximately 0.125 inch of thread remaining. Slide the unit over the screw and secure it by pushing it downward. The screw may need to be adjusted towards or away from the mounting surface for a more secure fit. Ensure that the arrows of each sensor are facing each other.
Diagram Description (Fig. 4): Illustrates mounting the unit on a wooden gate, showing the screw hole placement and sensor alignment.
Mounting Indoors on Gates
Using the provided mounting template, mark the position of the screw hole on the desired mounting surface. Ensure that the arrows of each sensor are pointed towards each other. Mount the sensors so they are less than 1 inch away from each other using either double-sided tape or the provided screw. The wired portion of the magnetic sensor should be mounted on the non-moving portion of the mounting surface, and the standalone sensor on the door/gate.
Diagram Description (Fig. 5): Shows sensor placement on a gate and wall, with arrows pointing towards each other and a maximum distance indicator of 1 inch.
Operation
When the batteries are loaded, a red LED light on the front of the unit will flash once and a single beep will sound, indicating the unit is set up and ready to work. There will be an 8-12 second alarm delay with the red LED light flashing, after which the alarm is ready.
The Safe Pool is designed to sound a loud alert when children enter through a protected door/gate. When properly installed, the Safe Pool will allow adults to pass through the protected door/gate and immediately shut off the sounding alarm.
When powered, the Safe Pool is always in protected mode. The alarm activates the instant the door/gate opens by more than 1 inch (when the magnetic sensors are apart by more than 1 inch). The alarm sounds continuously until the BYPASS button is pressed.
When passing through the door/gate from the opposite side (where the additional BYPASS option is included, S189A does not include this), press the outside mounted BYPASS button to temporarily disarm, open the door, enter, and close the door quickly. The unit will re-arm itself within 8-12 seconds.
Maintenance
When the alarm volume becomes low, or the unit does not produce a normal alarm sound, the red light will illuminate. Replace with (3) 1.5V AAA batteries.
The Safe Pool's plastic resists ultraviolet rays from direct sunlight exposure. However, slight discoloration over time is normal.
Warnings
THE SAFE POOL ALARM IS EXTREMELY LOUD WHEN ACTIVATED. FOR YOUR SAFETY, NEVER PLACE THE UNIT CLOSE TO YOUR EARS. TO TEST THE ALARM, ALWAYS USE EAR PROTECTION AND DIRECT THE UNIT AWAY BEFORE TESTING / ACTIVATING THE ALARM.
IT IS PROHIBITED BY LAW TO REMOVE THE INSTALLED ALARM AFTER IT HAS PASSED INSPECTION!
Warranty Information
A dated proof of purchase is required for warranty service.
Customer Service
Phone: 1-888-8TECHKO (1-888-883-2456)
Website: www.techkousa.com
Manufactured by TECHKO®
9767 Research Drive, Irvine, CA 92618-4626
MADE IN CHINA
Product Diagrams
Diagram Description (S189A UNIT / S189D UNIT): Shows the main alarm unit with a bypass button and LED indicator, and the separate magnetic sensors. The S189D unit diagram also indicates the optional additional delay button and magnetic sensor.
Diagram Description (Parts List - Fig. 2): Shows the main unit, a bypass button, screws, and double-sided tape as included components.
Diagram Description (Mounting Indoors - Fig. 3): Illustrates how the unit is mounted by sliding it onto a screw or attaching it with double-sided tape.
Diagram Description (Mounting Outdoors/Indoors on Gates - Fig. 4/Fig. 5): Shows sensor placement on a door/gate and wall, with arrows pointing towards each other and a maximum distance indicator of 1 inch. Also depicts application on sliding screen and glass doors.
