Instruction Manual for MBRP models including: 2015, 2024, S7213 Mustang 5.0 Coyote GT X Pipe, Mustang 5.0 Coyote GT X Pipe, Coyote GT X Pipe, GT X Pipe
MBRP Mustang 5.0 Coyote GT X-Pipe (2015–2024 ) – Auto-Hentzschel GmbH
Figure 1 Figure 2 Figure 3 Figure 4 S7213 © 04/25 Removal of Stock System 1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. 2. Remove the 2-piece undercar brace. [Convertible Only] Refer to Figure 1. 3. Remove the M8 bolts from the mid hanger brackets and remove them from the vehicle. Retain these parts as they will be reused. Refer to Figure 2. 4. Loosen both clamps ahead of the resonator, lift the lock tabs and slide the clamps rearward to disconnect the OEM cat-back from the front section of the exhaust. Use caution, The OEM cat-back is one piece and heavy. Refer to Figure 3. 5. Remove the OEM cat-back by lowering the inlet end and sliding the assembly forward to remove it from the rear hangers. Remove the OEM clamps as they will be reused. 6. Unbolt and remove the rear hanger brackets. Retain these parts, they will be reused. Installation of MBRP Performance Exhaust 1. Lay the Resonator Bypass Assembly on top of the OEM cat-back being sure the inlets are aligned with each other. Note that the passenger-side outlet has more bend angle than the driver-side outlet. Transfer marks from the end of the Resonator Bypass Assembly to the OEM cat-back. Refer to Figure 4. 2. Measure 2" Forward of the marks made in step 1 and scribe a cut line on the OEM pipes. The cut lines should be at the end of the straight section of pipe right next to the bends exiting the OEM Resonator. Using a reciprocating saw or similar tool, cut and deburr the OEM pipes. Refer to Figures 5 and 6. PAGE 2 OF 3 Figure 5 Figure 6 Figure 7 Figure 8 S7213 © 04/25 3. Reusing the original clamps, install the Resonator Bypass Assembly being sure that the outlet with more bend angle is located on the passenger side of the car. Ensure the Assembly is installed level as viewed from the rear and tighten the clamps. Refer to Figure 7. 4. Install a 2.5" Clamp onto the passenger side outlet of the Resonator Bypass Assembly. Reinstall the passenger-side of the OEM cat-back using the previously removed mid and rear hanger brackets. Refer to Figure 8. 5. Reinstall the driver-side of the OEM cat-back using the procedure illustrated in step 4. 6. Install the undercar brace [Convertible Only] using the previously removed hardware. 7. Carefully align the system and tips. Align the edge of each band clamp with the edge of the joint it is connecting. Tighten all hardware and clamps, starting at the front and working rearward to secure the system. Check along the full length of the exhaust system to ensure there is adequate clearance for fuel lines, vent lines, brake lines, frame, bodywork, suspension and any wiring, etc. If there is any interference detected, relocate or adjust to provide adequate clearance. Ensure all clamp connections are secure and components are unable to rotate or slide. Band clamps (excluding tip hardware) require approximately 45 lb-ft (60 N-m) of torque. Verify clearances, system security and band clamp torque after 30-60 miles (50-100 km) of driving. Congratulations! You are ready to begin experiencing the improved performance and driving pleasure of your MBRP performance exhaust system. We know you will enjoy your purchase. PAGE 3 OF 3Microsoft Word for Microsoft 365