Products - GenexisGenexis - Market leader in CPE's and residential gateways
Installation Guide for genexis models including: G2110, G2110 FiberBox, FiberBox
FiberBox |
File Info : application/pdf, 5 Pages, 761.50KB
DocumentDocumentFiberBox G2110 Installation Guide Installation guide Box contents · Genexis FiberBox · Power adapter · Labels (self-adhesive) Label position The product label is positioned on the back of the device. Preparation Ensure there is a power socket within reach of where the device is being installed. Important: Instructions need to be followed precisely and uninterrupted. This minimizes the risk of damage to the fiber optic connectors, causing a severe degradation of signal quality. Placement The product supports two placement options; desk placement and mounted to a wall. It is recommended to place the device `away' from obstacles and objects. Desk placement 1. Place the device horizontally on a flat surface. Wall mount 1. Download and print the drilling template from https:// genexis.eu/product/fiberbox/ downloads 2. Use the drilling template to drill holes, insert plugs and put screws into place. 3. Use the wall mount points on the back of the FiberBox to mount the device to the screws. Connecting the FiberBox 1. Open the green shutter from the WAN port, insert the fiber patch cable from your fiber outlet into the WAN port. 2. Connect your gateway to the LAN port via an RJ45 network cable. 3. Connect the supplied power adapter to the FiberBox and plug the adapter into a power socket. 4. Press the ON/OFF button to power on the device. Warning: This product contains a laser that emits invisible light. It is a Class 1 Consumer Laser product according to EN 50689:2021, which means it is safe under all conditions of normal use. However, it is still advised to not look directly into the fiber connector when the product is powered on. Warning: Do not cover the device, this will interfere with the ventilation. Ambient Operating Temperature: 0°C ~ 40°C Port overview Reset button Power port WAN port LAN port ON/OFF button ON/OFF button Power ON or OFF press and release to switch device ON or OFF Reset button (recessed) Reset - press and release Factory reset - press and hold the button until System and Uplink LED start to blink LED overview System Green system ok Green (blinking) booting Red - system or boot failure Red (blinking) - insufficient PON signal Off power off Uplink Green link ok Green (blinking) link establishing Off no link System + Uplink Green (blinking) firmware upgrade EU Declaration of Conformity Hereby, Genexis Netherlands B.V. declares that the product FiberBoxG2110 is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, Delegated Directive 2015/863 and Ecodesign Directive 2009/125/EC. The full text of the EU declaration of conformity is available at the following internet address: https://genexis.eu/product/fiberbox/red/ fiberbox-g2110 Company Name Genexis Netherlands B.V. Signature of authorized person Company Address Lodewijkstraat 1a 5652 AC Eindhoven The Netherlands Name and title of authorized person Maarten Egmond, CTO Place of issue Eindhoven The Netherlands Date of issue 2023-12-20 Revision 1.0- December 2023 - Copyright © 2023 Genexis Netherlands B.V. All rights reserved. Multiple languages of this document and additional product information are available on https://genexis.eu/product/fiberbox/downloads Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.