Traceable® 3-Channel Timer
Brand: Traceable
Model: 5665
Overview
The Traceable® 3-Channel Timer is a versatile device for timing multiple events simultaneously. It features individual channel control, an all-channel start/stop function, and adjustable alarm volume and duration.
Initial Setup
The timer requires initial setup before use:
- Remove the battery compartment cover and insert batteries.
- Adjust the buzzer volume using the volume control slider (lo/hi).
- Set the alarm duration using the duration slider (e.g., 1 min).
- Replace the battery compartment cover.
- Press the 'Timer/Clock' button until the desired time display appears.
- Press and hold the 'Timer/Clock' button until an audible beep is heard.
- Set the time using the 'H' (hours), 'M' (minutes), and 'S' (seconds) buttons, then press the 'Timer/Clock' button.
- Set the alarm and date using the 'H/M/S' buttons. To activate the alarm, press the 'Start/Stop All' button when the alarm indicator is flashing. The display will show 'ALARM' when active.
Setting a Timer
To configure individual timers:
- Press the 'Timer/Clock' button until the timer mode is displayed.
- Press and hold the 'Start/Stop' button for the specific channel you want to configure.
- Use the 'H', 'M', and 'S' buttons to set the desired time for the timer.
- Press the 'Start/Stop' button for that channel to confirm and set the timer.
Note: To recall a previously set timer after it has sounded an alarm, simply press the 'Start/Stop' button for that channel.
Starting and Stopping Timers
- To start or stop a single timer channel, press the 'Start/Stop' button corresponding to that channel.
- To start or stop all timer channels simultaneously, press the 'Start/Stop All' button.
Note: If a channel is not configured with a specific time, pressing 'Start/Stop' on that channel or 'Start/Stop All' will initiate a count-up timer for that channel. The display will show 'TIME UP' flashing on that channel.
Warranty, Maintenance, or Recalibration
Traceable products are quality certified according to ISO 9001:2015 by DNV and accredited as a calibration laboratory according to ISO/IEC 17025:2017 by A2LA.
For warranty, maintenance, or recalibration, contact Traceable:
Address: 12554 Old Galveston Rd. Suite B230, Webster, Texas 77598 USA
Phone: 281-482-1714
Fax: 281-482-9448
Email: support@traceable.com
Website: traceable.com
Article No.: 56000-13
Model No.: 5665