Programming Instructions

Disclaimer: All currently programmed and new remotes must be reprogrammed to your vehicle. Please have all remotes in hand at the time of programming.

Once plugging the programmer in you will have 2 minutes to program all new and existing remotes to the vehicle. After 2 minutes your session will time out and your vehicle will no longer be in programming mode. Programmer will work for no more than 3 sessions.

1. Close and lock doors.
2. Insert Key into ignition and turn to IGN ON. (Do not crank)
3. Insert Programmer into your vehicle's OBD2 Port. This port is typically located underneath the dashboard below the steering wheel. It may be covered by a faceplate that will easily pop off.
4. Once the Programmer is inserted, wait for a chime or orange light on the Programmer to come on. This will indicate that the unit is ready to program the first remote.
5. Press and hold the lock and unlock button on the remote simultaneously until you hear a chime, buzzer, or the door locks cycle (approximately 10-15 seconds)
6. To program additional remotes, repeat step 4.
7. When all remotes are programmed wait 60 seconds for buzzer to sound continuously, then remove programmer from OBD2 Port.