Installation Guide for KINESIS models including: Advantage360 Pro Keyboard, Advantage360 Pro, Keyboard

Advantage360 Professional - Firmware Update Instructions 11.10.22 v2 (KB360-PRO-GBR)

dhargreaves

Installing Firmware on the Advantage360 with the ZMK Engine ...

Nov 10, 2022 — Your Advantage360 Pro was built with the latest branch of custom ZMK firmware as of its build date, but Kinesis may release newer versions of firmware to ...

To update the firmware, perform the following steps

Title: - Advantage360 Professional - Firmware Update Instructions 11.10.22 v2 (KB360-PRO-GBR) Author: dhargreaves Created Date

Step-by-Step Advantage360 Professional (ZMK) Firmware Installation Instructions

Kinesis Advantage360 Pro (ZMK) Keyboard | Technical Support


File Info : application/pdf, 1 Pages, 188.68KB

PDF preview unavailable. Download the PDF instead.

Step-by-Step-Advantage360-Professional-Firmware-Installation-Instructions-KB360-PRO v11-10-22
Installing Firmware on the Advantage360 with the ZMK Engine (KB360-PRO)*

Version: 11/10/2022

Your Advantage360 Pro was built with the latest branch of custom ZMK firmware as of its build date, but Kinesis may release newer versions of firmware to improve performance and the ZMK community release their own updates on GitHub. Not all branches of firmware will support all features and some branches may be experimental.

Each time you customize your Advantage360 Pro layout you will need to download your custom firmware files and flash those to each module of the keyboard.

Build your own firmware: github.com/KinesisCorporation/Adv360-Pro-ZMK

Consult the User Manual for detailed instructions.

To update the firmware, perform the following steps:

1. Once you have obtained valid Advantage360 Pro firmware files (".uf2" files) from GitHub or

Kinesis you will need to "flash" them on to each keyboard module. Note: There are separate

Left and Right versions and installing them on the wrong key module will have negative

consequences.

2. Connect the left module to your PC using the included cable.

3. Place the left module into bootloader mode by using a paperclip

to quickly DOUBLE-CLICK the Reset Button shown at right. The

Indicator LEDs with flash white and then change to solid green

to indicate bootloader mode. A new removable drive called "ADV360PRO" will appear on your PC in the "file explorer"

Reset Buons

application (or equivalent).

Troubleshooting Tips and Tricks

 The timing of the double click is critical so it may take a couple tries to get the hang of it.

 It is not necessary to remove any keycaps to access the buttons

 Keystrokes are disabled while in bootloader mode.

 If the drive does not appear, rotate the cable 180 degrees and reconnect it, and then

double-click the Reset button again.

 The Shortcuts Mod + Hotkey 1 (Left Bootloader) and Mod + Hotkey 3 can also be used

to place the respective modules into bootloader mode but they will not work if the right

module is flashing red.

4. Copy and paste the left.uf2 firmware file to the "ADV360PRO" drive. The keyboard will

automatically install the file and disconnect the removable drive.

DO NOT DISCONNECT THE CABLE UNTIL THE KEYBOARD LEDS STOP FLASHING.

5. Repeat steps 2-3 with right module and the right.uf2 file.

6. Once both sides have been updated, you are ready to go.

DO NOT ATTEMPT TO RUN DIFFERENT VERSIONS OF FIRMWARE ON THE MODULES.

*Advantage360 SmartSet models have a different firmware installation process:

Advantage360 Firmware: kinesis.com/support/kb360/#firmware-updates



References

Acrobat Distiller 22.0 (Windows)