Instruction Manual for Holley models including: 2019-2022, Ram Gauge Mounting Arm, Gauge Mounting Arm, Mounting Arm, Arm
Gauge Mounting Arm Installation Instructions 2019-2022 Ram
Gauge Mounting Arm Installation Instructions 2019-2022 Ram Materials Nut Dual Tab Mounting Arm Washer Bolt Required Tools 10 mm 1/4" drive Socket, deep or regular 3 1/4" Drive Extension 1/4" Drive Socket Wrench Small 1/7" Flat-blade Screwdriver 4 mm Allen Wrench 2 Mounting Arm Installation 1. On the driver's side A-pillar grab handle, carefully remove the lower cover by prying it loose using a screwdriver. 2. Remove the exposed bolt. Keep the cover and bolt should you wish to return the vehicle to stock. 3. Using the hardware included with the mounting arm, install the flat washer on the bolt and insert the bolt through the mounting arm. 4. Insert the mounting arm into the hole and use an Allen wrench to tighten the bolt into the pillar. 5. Remove the dual tab and nut from the bag. If the dual tab and nut are screwed together, unscrew them slightly from one another until the nut moves freely. 6. Snap the nut and dual tab over the ball on the mounting arm and tighten the nut (if the nut won't go onto the ball, the tab and nut may need to be unscrewed further). 7. Attach your device to the dual tab and secure the cord. Adjust the device position using the dual tab/nut. Before After 3 For additional questions not found in the user guide, call: Holley Technical Support: (888)-360-3343 Mon - Fri 8:00 am - 5:00 pm MST, Sat 8:00 am - 2:00 pm MST To expedite your support call, please have your Vehicle Information, Part Number, and Serial Number ready prior to calling Technical Support. © Copyright 2022 Holley Inc. and subsidaries. All rights reserved. D10026500 Rev02 11/08/2022Adobe PDF Library 16.0.7 Adobe InDesign 17.4 (Windows)