Instruction Manual for SHANTOU models including: 2BEH7-710-B3, 2BEH7710B3, 710-B3 Alloy Remote Control Die Cast Excavator, 710-B3, Alloy Remote Control Die Cast Excavator, Remote Control Die Cast Excavator, Control Die Cast Excavator, Die Cast Excavator, Excavator
Shantou Chenghai Wanlilong Plastic Toy Factory 710-B3 Remote Control Car 2BEH7-710-B3 2BEH7710B3 710 b3
ALLOY REMOTE CONTROL DIE-CAST EXCAVATOR Front/reverse digging Alloy bucket Console rotation 2.4G remote control Lithium battery lights/sound 12 Channel Remote Control Introduction 12-CHANNEL FUNCTION: that is, 12 independent keys, each key corresponds to a function, with independent programming demonstration function. Forward Backward Automatic Demo Unload Excavate The cab can turn left The cab can turn right OFF ON Sound OFF/ON Light Turn left Turn right 1.5V AA 1.5V AA INSTRUCTION MANUAL Thank you very much for purchasing our products. Engineering Series :Alloy version 12 channel remote control excavator. Before using this product, please read the user's manual carefully for correct and safe use. Be sure to save the instructions for your reference. Charging Method 1 2 Turn to open the buttonlock, lift the battery cover of the excavator, and press the clamp to remove the battery. 3 Press the battery charging port into the configured charger jack. 4 USE 2x1.5V"AA"NON-RECHARGEABLE BATTERY(NOT INCLUDED) Forward/backward The cab can turn left The cab can turn right When connected to the socket, the light indicates that the battery is charging. 5 Turn to open the button lock, lift the battery cover of the excavator, and install the rechargeable battery. Function Introduction When the light goes out, the rechargeable battery is fully charged. 6 OFF ON MADE IN CHINA Open the switch ON the base of the excavator to "ON". Start playing with the alloy excavator. Forward Backward OFF ON The cab can turn left The cab can turn right OFF ON Excavate/unloading / OFF ON Unload Excavate OFF ON Turn left Turn right Turn left/Turn right FCC Caution. (1)§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Changes or modification warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.Adobe Illustrator 28.0 (Windows) iLovePDF